Electronics Forum | Wed Jan 20 08:49:46 EST 2010 | edmaya33
I heard some of the manpower of KY transfer to VI technologies to introduce a new technology, same manner as of KY had. This french owned company post an impressive Inspection machine ( Both AOI and SPI ). Going back to ORBOTECH P36+, is there any
Electronics Forum | Wed Sep 14 02:41:49 EDT 2016 | bukas
here is well explained SMEMA interface http://www.daghee.com/?p=326 so, disconnect printer from upline modules and check are any 2 of 4 pins shortened(should be pins No 1 & 2) while machine is ready state. when machine is in busy state the same pin
Electronics Forum | Thu Sep 15 06:45:26 EDT 2016 | awhite
Hi Ariss_T, Thanks! I actually did check that...that was one of my first thoughts as well. While in the I/O, I slide a raw board back and forth under the camera/sensor and it acted appropriately. I will definitely update this thread as new informa
Electronics Forum | Sat Mar 19 04:31:37 EDT 2022 | SMTA-69080803
What are the feasible options in mounting an alternative component onto a PCB that has a different footprint? PCB redesign is not a good option because the component is used on several other PCBs. The component is very small (8-lead SOT-23) so fabric
Electronics Forum | Thu Jul 14 16:05:55 EDT 2005 | russ
Good answer slthomas! This has got to be the biggest misconception out there. To perform SPC on a wave process you must first perfrom DOE to determine the critical parameters and or control limits. For example you will need temp reading devices tha
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Tue Jul 09 15:20:19 EDT 2002 | pjc
When you look at the capabilities of Combo machines they tend to sacrifice performance when compared to separate X-ray and AOI machines, meaning they don't do either the X-ray or AOI operations as well as a machine that was designed to do only one. A
Electronics Forum | Wed Jul 26 18:23:47 EDT 2000 | Gary
I have been following forum discussions here and eslewhere, attended technical sessions at APEX and have been experimenting with the paste-in-hole process on some of our new product. I have run into one problem I have never seen mentioned, that is a
Electronics Forum | Thu May 28 10:57:10 EDT 1998 | John
Our company is currently looking to implement a SMT production line. What I am looking for is feedback on people's experiences with various machines. Here's what we are in the market for: Low/Mid volume 3,000+cph machine that can handle high job fle
Electronics Forum | Wed Sep 10 12:56:09 EDT 2003 | davef
Intermetallic compounds [IMC]: * Form during the alloying process of some metals. In soldering these are Sn, Ni, Ag, Cu, Au. * Do not accept solder. * Increase in depth in logarithmic proportion to both time and temperature. [So during the solder