Electronics Forum | Thu May 17 11:39:38 EDT 2012 | stentech
Hi again quickly. Anyone need a sample let me know ..no charge. I would be evry interested in your findings and can give many references for you to talk to..customers. Scott I am working on a project with different cut parameters very time consuming
Electronics Forum | Tue Apr 20 20:10:16 EDT 2004 | Indy
Hi Everyone, I am trying to stencil print chipbonder. The problem I am having is with the cleaning of stencil. The apertures are gettting blocked and cleaning with alcohol is not helping. Could anyone suggest a better way of cleaning the stencil. I
Electronics Forum | Mon Mar 26 19:48:22 EST 2001 | pzohbon
In regards to cleaning RMA solder paste from stencils; Right now we are cleaning the stencils by hand. I want to get away from this by going to an automatic cleaner. Any recommendations for ultrasonic stencil cleaning systems using 440-R SMT deterg
Electronics Forum | Thu Mar 29 18:14:19 EST 2001 | kerryn
Hi Dave, I looked into the South Coast Air Quality Management District Clean Air Solvent Certification when I was having my problems with VOCs. The problem with the SCAQMD CAS Certification is that it only certifies chemicals as they are found in t
Electronics Forum | Mon Apr 13 19:35:11 EDT 1998 | Mike Konrad
Aqueous Technologies manufacturers a "no-frills" stencil cleaning system. The Model designed to handle stencils up to 24" x 24" is available for under $ 10K. This system is, however, not ultrasonic, rather spray-in-air. If you desire information, c
Electronics Forum | Tue Jul 02 16:04:08 EDT 2002 | russ
We normally disregard what the "tech" sheets say. A lot of it has to do with your printer settings, prints per hour, placement time, stencil cleaning procedures etc... Just another wrench to throw in, We have noticed lot to lot paste differences al
Electronics Forum | Tue Apr 20 23:14:51 EDT 2004 | Maneet
ou can use the air gun to clean the apreture.Also contact to your Glue manufactrure.
Electronics Forum | Tue Mar 07 21:19:50 EST 2000 | Van Hoang Dinh
I have few problems below, 1.I had problem with clean glue stencil at the midle of the process and after the process. 2.Very hard to Fix the bridging on the (close pin) connectors through the wave. Anyone can help on this. Thanks Van
Electronics Forum | Tue Mar 07 21:19:50 EST 2000 | Van Hoang Dinh
I have few problems below, 1.I had problem with clean glue stencil at the midle of the process and after the process. 2.Very hard to Fix the bridging on the (close pin) connectors through the wave. Anyone can help on this. Thanks Van
Electronics Forum | Thu Dec 06 02:45:09 EST 2007 | mun4o
hi, we use pump print stencil and have problem with cleaning.we clean the stencil handling, using zestron301, but in the holes stay adhesive.Take a test with ultrasonic cleaner but resalt is not good.
.png)
