Electronics Forum | Tue Feb 05 14:41:45 EST 2013 | mowens
I am looking for a nice storage rack for foil type stencils, not the frame type. Some thing compact yet easy to work with. Any directions/advice. Thanks in advance.
Electronics Forum | Tue Feb 05 19:25:54 EST 2013 | swag
We have a few Bliss racks. They were made for 29x29 frames but we use them for vectorgaurd and foil. DEK ships vectorgaurd stencils in a nice, thin cardboard box. We use these boxes for storing vectorgaurd + foils. You can store a handful of foil
Electronics Forum | Wed Feb 06 12:52:44 EST 2013 | mowens
That is a good idea, I was able to find the big file folder before, I can't even find those now. I thought I saw one that had little sliders with hooks to hang the stencil from. Thanks for the info.
Electronics Forum | Tue Oct 11 10:49:14 EDT 2005 | jhagve
HI We start to make a product which have a 0.4 mm pitch IC and start having problems with not enough solder printed, to solve this problem we had to increase the manual cleaning, now we are cleaning the stencil every 8 printings, before we was runnin
Electronics Forum | Fri Mar 29 04:06:42 EST 2002 | bayanbaru
Is there a cheap and effective method for stencil cleaning? Getting a equipment is out of the question.
Electronics Forum | Fri Oct 14 19:41:06 EDT 2005 | KT
We encounter this kind of issue. We use stencil clean in the stencil printer and also use air to blow aperture after cleaning. We are having some luck !!
Electronics Forum | Tue Apr 02 13:35:02 EST 2002 | Mike Konrad
Hi Dave, God no! I am not suggesting that anyone should clean stencils by hand. My answer was facetious. The questioner asked is there was a �cheap and effective� way of cleaning stencils without purchasing equipment. Cleaning stencils by hand m
Electronics Forum | Fri Oct 21 14:13:08 EDT 2005 | mafc65
1.- Clean bottom and top stencil with a cloth/alcohol at same time.Pay special attention to fine pitch locations. 2.- Clean again bottom stencil side .To prevent any residual of solder 3.- Blow air with a air gun under the stencil to remove the solde
Electronics Forum | Thu Dec 06 20:58:53 EST 2001 | chinaren
Hello,everyone: Would you like provide me some information about the equipment you use for the stencil cleaning and the solvent that is effective or you are satisfied with the cleaning result? best regards
Electronics Forum | Mon Apr 01 19:12:16 EST 2002 | Mike Konrad
�Cheap� is relevant. Is $ 3,500 for equipment cheap or expensive? If $ 3,500 is cheap, than we have a solution for you. If $ 3,500 is expensive, then purchase pre-saturated chemical wipes, latex gloves and a hazardous waste bin. As for �effective
winsouce.jpg)
