45 stencil design for 0.4mm pitch results

Electronics Forum: stencil design for 0.4mm pitch (Page 1 of 5)

0.4mm PCB Thickness - production issues

Electronics Forum | Wed Sep 13 20:04:37 EDT 2006 | mika

Hi, We have a customer that want us to produce a single sided 0.4 x 100 x 50 mm size RoHS pcba approx 1000 of them. The board only contains three 2.54mm pitch Non P.I.P, SMT-connectors. We have never produced such a thin pcb:s before. We are thinkin

0.4 mm Pitch BGA stencil design

Electronics Forum | Mon Nov 01 10:29:13 EDT 2010 | scottp

I've searched the archives and maybe my search skills aren't up to snuff but I couldn't find much. I'm curious what people are doing for 0.4 mm pitch BGAs, assuming a type 4 paste. Pad diameter? SMD or NSMD? Stencil thickness? Aperture diameter? Us

stencil apertures for BGA

Electronics Forum | Fri Apr 11 06:22:04 EDT 2008 | andrzej

Hi Andrzej, > > We are using for BGA (0.8 pitch) > square apertures size 0.4 mm (rounded corners r = > t) and stencil thickness t=5 mils. So area > ration-_ w/4t=0.8 > > Regards Jan Hello Jan, I understand that you have the same pad dimensio

Stencil type and design for 0.65mm pitch QFP100

Electronics Forum | Wed May 10 01:00:09 EDT 2000 | gary

0.65mm pitch QFP. I believe that this is the borderline for Fine Pitch. Will I have a good paste release with Chem-etch matched with a rubber squeegee? I'm planning of a 15% reduction on the Width and no reduction on the length. Any feedback whether

Stencil design

Electronics Forum | Fri Mar 02 00:21:38 EST 2007 | AMS

Hello, I havea 0.4mm pitch TQFP with heat transfer pad on the bottom side of component. I will appreciate any suggestions with regards to: 1) stencil thickness (Rest of components on board are 0603 passives and few 40 mil pitch IC's) 2) Stencil

Stencil Design for BGA with 0.2 mm Diameter Pad and 0.4 mm pitch

Electronics Forum | Thu Nov 14 10:52:56 EST 2019 | jandon

Maybe something like this could work?

Stencil Design for BGA with 0.2 mm Diameter Pad and 0.4 mm pitch

Electronics Forum | Tue Nov 12 00:49:37 EST 2019 | myke03o

I am optimizing a stencil opening for BGA with 0.4mm pitch and pad diameter of 0.2mm. Can anyone advice of stencil thickness and stencil opening I can use in order to have a good paste release. Thanks for all your answers.