Electronics Forum | Mon Sep 20 06:21:05 EDT 2004 | C Lampron
Hi Chris, Acually, it worked pretty good. We made a new blade from SS. We were not sure if it would work so we diddn't want to commit a good sqeegee blade. You will want to try to keep the cutaway toward the center of the blade. And don't hit the fl
Electronics Forum | Fri Sep 17 09:31:33 EDT 2004 | C Lampron
Hi Chris, It sounds like you may have to go with your idea of a relief cut into the stencil. Are there any components that need to be printed in close proximity? Is this a high volume?I used to work at a flex house and we had a similar situation. We
Electronics Forum | Thu Sep 16 07:07:34 EDT 2004 | C Lampron
Hello Chris, "It sticks up about 3/8" or so above the surface of the board." Is this over the ridgid portion of the PCB or in between? Is it possible to create a support fixture for printing that has relief that will allow the flex to bow downward i
Electronics Forum | Thu Sep 16 15:28:06 EDT 2004 | rohman23
Actually, it's not even close to 3/8". It's more like 0.075"...not sure what I was smoking last night (I tried to guess on dimensions from my house, and now I have one in front of me). Anyway, to answer your question, the bulge is in between side A
Electronics Forum | Sun Sep 19 10:54:24 EDT 2004 | rohman23
This (along w/ everything else we do) is not high volume. Actually, we're dropping a batch of 7 the first of the week, and that's fairly sizeable for us. I talked with my stencil design folks and sent them a scrap board and all my gerber info. I t
Electronics Forum | Wed Sep 15 22:01:34 EDT 2004 | rohman23
We've had a few problems with printing a flex-rigid PWB, and I'm hoping some of you could throw some opinions/suggestions my way. Our PWB is about 8" x 11" divided into two parts (side A & B) by 2 wide flex cables. Each of these flex cables is ab
| 1 |
