Electronics Forum | Mon Aug 14 13:21:48 EDT 2023 | calebcsmt
the implication being the soldermask is too thick, raising the top of the board higher than the pads themselves (eliminating gasketing)? Essentially, the board isn't perfectly planar would be the subject of cause it sounds like?
Electronics Forum | Thu Sep 20 09:12:28 EDT 2001 | jschake
If you were successful in running the machine in dry cycle mode, then I would expect with new squeegees that the prints would be acceptable. To give you more tangible data on what you may expect from the actual print results, maybe you could run the
Electronics Forum | Wed Jan 08 14:36:44 EST 2003 | davef
It depends on your product requirements. We don't like to print off-pad, because: * Tough to control the amount of paste that squirts onto the board, because the aperture is not gasketed to the pad on the board. * Some paste that squirts between the
Electronics Forum | Thu Mar 25 09:38:36 EDT 2021 | spoiltforchoice
Well everything Graham said with some additional points.. You mention manual printing but very little about your stencil or setup. Everything you have said indicates a very limited budget has been expended, however what you have is an extreme exampl
Electronics Forum | Fri Mar 23 14:13:20 EST 2001 | mnaddra
RW, I have Screened Adhesive on to several different assemblies and have found that when it is possible I get a much better result than with a dot deposition process (The green strength was greatly improved), the biggest issue I ran in to was the pr
Electronics Forum | Mon Sep 13 09:49:16 EDT 1999 | John Thorup
| | I noticed that some of our pcb's component legend/designation are unreadable as they are placed under smt pads. Is this correct and according to standard? Although we don't have any problems with them as of now, I would like to know the effects o
Electronics Forum | Thu May 30 11:12:38 EDT 2002 | robbied
If I get you right and you are looking for a micro stencil for bga rework, then you should try http://www.circuittechctr.com. They are offering a free sample of their Flextac micro stencils in a wide range of sizes. The thing with these ones is that
Electronics Forum | Mon Aug 14 13:48:03 EDT 2023 | spoiltforchoice
Well gasketing yes, have you dine enough analysis to blame aperture design- Maybe not? Maybe whip out the gerber files for this PCB&stencil and compare the details with one you feel works well. Is there something different about their layout rules o
Electronics Forum | Sun Sep 12 10:08:55 EDT 1999 | Earl Moon
| hello | | having a problem with one customers bare boards not matching my stencil apertures. i design stencils based on gerber data and reduce up to 15% on some pads. do some board houses reduce pads after receiving gerber data???why would they d
Electronics Forum | Mon Sep 13 04:11:27 EDT 1999 | Earl Moon
| | hello | | | | having a problem with one customers bare boards not matching my stencil apertures. i design stencils based on gerber data and reduce up to 15% on some pads. do some board houses reduce pads after receiving gerber data???why would