Electronics Forum | Wed Dec 29 19:08:42 EST 2021 | cyber_wolf
Try these guys. https://www.smtxtra.com/product-category/screen-printers/mpm-speedline-screen-printers/
Electronics Forum | Wed Apr 26 16:18:45 EDT 2023 | cyber_wolf
What model MPM ?
Electronics Forum | Wed Apr 26 18:35:07 EDT 2023 | poly
I'm looking to make a board support table fixture that is connected to the printer and uses the vacuum manifold of the printer. Printer is an mpm Accela
Electronics Forum | Wed Apr 26 19:10:43 EDT 2023 | cyber_wolf
This machines support table looks similar to AP and UP machines. I believe MPM published the dimensions of the "H" tower that the dedicated plates bolts to. As far as the plate, they are typically (2) pieces with the inside hollowed out to allow for
Electronics Forum | Wed Apr 26 06:51:11 EDT 2023 | poly
I'm looking to make dedicated tooling for my mpm stencil printer. We only make 3 different boards and they are the same size panel so I'm planning to make one bit of tooling for them. One board is 0.6 mm and sometimes I have problems with it not bein
Electronics Forum | Mon Jun 18 08:38:41 EDT 2007 | babe7362000
I need the passwords to mpm Up2500 Stencil printer. I have the supervisor one, but my coworker took the rest with him when he left. If anyone could give me the default ones, that would be great. I am trying to get everything done before vacation t
Electronics Forum | Fri Feb 13 18:08:06 EST 2004 | bman
We have recently aquired an MPM SPM stencil printer with an under stencil wiper. I have a list of approved solvents from MPM, but before I go and buy one I thought I would see what the fine people of SMTnet are using for their wiper solvent needs.
Electronics Forum | Mon Feb 16 16:23:32 EST 2004 | blnorman
We tried Ionox BC in our MPM, but evidently a feed line came loose allowing the Ionox to spray, flood, whatever on the inside of the machine. The Ionox ate through some of the insulation on the wires. As long as it stayed in the plumbing, it worked
Electronics Forum | Mon Feb 23 13:12:55 EST 2004 | Mark
I have used MPM 3000 and Dek 265 Horizon. We always just fill them up with regular old alcohol. Cheapest and easiest way to maintain.
Electronics Forum | Mon Feb 23 12:22:32 EST 2004 | esoderberg
I have an MPM SPM and two Ekra E4 screen printers. I have always run them dry with vacuum. I am also using no-clean paste and have not had a problem. The volume I run per day on the machines is 4 - 6,000 bds
winsouce.jpg)
