Electronics Forum | Thu Jun 02 19:42:24 EDT 2005 | garymizuno
I'm still buying my solder printer cleaning rolls from my manufacturer. Does anyone know of any after market brand that is as good in quality and atleast half the price. I am paying $80.00 a roll. Gary
Electronics Forum | Wed Jun 09 16:54:24 EDT 2004 | Ralf
Hi all I have a question to all of you who has experiences with Microflex MPM. There are two items: one is on contact calibration and second squeegee pressure calibration. Do i have to if i set PCB make these calibration?. Does Microflex have mechani
Electronics Forum | Wed Dec 10 13:03:15 EST 2003 | alden
The UP3000 is the generic name for the model series. The UP3050 has the following options as standard features on the machine: Vacuum Stencil Wiper Paste Dispenser Auto Pin Placement Auto Stencil Change 2D Inspection 3D Inspection
Electronics Forum | Fri May 21 14:51:29 EDT 2004 | cyber_wolf
The sprayer is supposed to be aimed at the part of the wiper paper that comes in contact with the stencil.(Not @ the stencil) We have 4 SPM's and 2 AP25's and never had a need to use the solvent sprayer. Dry wiping works just fine. Print on !......
Electronics Forum | Tue Mar 22 11:48:33 EDT 2011 | cyber_wolf
Make sure the paper is advancing correctly on your stencil wiper. I have seen this cause major issues. If the paper hangs up, it will smear paste across the bottom of the stencil every time it wipes.
Electronics Forum | Tue Mar 22 11:57:07 EDT 2011 | jercole
Make sure the paper is advancing correctly on > your stencil wiper. I have seen this cause major > issues. If the paper hangs up, it will smear > paste across the bottom of the stencil every time > it wipes. We are manually cleaning the stenci
Electronics Forum | Thu May 09 10:00:19 EDT 2002 | brianockert
I'd tend to agree with what the others have said. Check the basics, board supports, setup, wiper paper working correctly. If it's a humidity issue, try taking some paste, place it on a chem wipe, and roll it around a bit, which removes some of the mo
Electronics Forum | Fri Aug 06 17:28:06 EDT 2004 | Steve
My suggestion is that there are alot of suppliers for this type product. Call a couple of distributors and have them send you samples. Make sure you know each manufacturer so that they don't duplicate. Review the performance and price of each one and
Electronics Forum | Tue Jun 28 02:37:17 EDT 2005 | grantp
Hi, Check to make sure your paste is not dried up, and it should roll across the stencil, not slide. Also, if your running in a cold environment, then that can stiffen up the paste, and it will still to the blades, and not roll over the stencil corr
Electronics Forum | Tue Dec 09 08:51:56 EST 2008 | pjc
256 LT or Lite, low end fully auto machine, lower res alignment camera, not as accurate and repeatable as GSX. Wiper and Auto Paste dispensing optional. GSX is fully loaded with hi end camera alignment, auto paste, vac stencil wiper, may have auto fl
