Electronics Forum | Wed Dec 15 20:17:48 EST 2004 | cmiller
We have switched from IIT pro-plates to QTS stencils. lots of companies provide them. We still buy from IIT, they have been one of the best suppliers we have had. The single axes tightening just does not get it anymore with the super small parts we h
Electronics Forum | Wed Jun 22 10:12:31 EDT 2005 | slthomas
I don't know how your printer could match the board's alignment to the stencil if they aren't. If you don't have fids on both board and stencil that match you'd have to use pads, but then you've got apertures thrown in to the mix. If that's the sit
Electronics Forum | Wed Sep 06 11:34:15 EDT 2006 | slthomas
I don't remember ever having that problem with my EKRAs, but you might look at how much fluid you're dispensing on to the cleaning medium if this is occurring while you're using wet cleaning cycles. It could be getting saturated to the point of weakn
Electronics Forum | Tue Sep 07 15:28:13 EDT 1999 | Earl Moon
Listed below are the issues Viking has been experiencing since the installation of the Proflow Head: 1. After installing new 350mm Wiper foil with metal strip glued on it, It worked for about a week and suddenly metal stri
Electronics Forum | Wed Sep 08 08:25:26 EDT 1999 | Brad Kendall
Listed below are the issues Viking has been experiencing since the | installation of the Proflow Head: | 1. After installing new 350mm Wiper foil with metal | strip glued on it, It worked for about a week and suddenly meta
Electronics Forum | Wed Feb 23 15:24:24 EST 2000 | Michael Uganecz
Steve, Give MPM/Speedline a call and see if they still sell the SPM-AV, it's a shuttle style printer with vision alignment. It has a really nice auto-align vision system that will move the table in x,y and theta. It's not a look up/look down syste
Electronics Forum | Wed Feb 23 15:24:24 EST 2000 | Michael Uganecz
Steve, Give MPM/Speedline a call and see if they still sell the SPM-AV, it's a shuttle style printer with vision alignment. It has a really nice auto-align vision system that will move the table in x,y and theta. It's not a look up/look down syste
Electronics Forum | Fri Jun 16 07:57:59 EDT 2006 | Bryan
Thanks to all for clarification - I now appreciate the different methodology between "in-line" & "end of run" but am still unclear as to advantages / disadvantages of paper versus non-woven material ie stencil rolls for in-line cleaning. Any info wo
Electronics Forum | Mon Mar 18 16:06:35 EDT 2013 | emeto
The paste is going to roll as before because you have to apply the coating on the bottom side of the stencil. Also the coating that wears out will most probably go to your stencil cleaning paper as that the process wehn you actually have friction wit
Electronics Forum | Wed May 05 06:30:40 EDT 2021 | jineshjpr
Do Proper underneath stencil cleaning. if the cleaning not effective, check Vaccuum section of the printer machine. Else change the Wipe roll. Trying out with other cleaning solvent (dedicated to stencil cleaner) also improve this issues.