Electronics Forum | Fri Feb 23 07:58:27 EST 2007 | realchunks
Does your camera / stopper move to a spot where it can catch the boad when the middle sensor is triggered? It sounds like you may have your board stop coordinates wrong. Check your X measurement to be sure.
Electronics Forum | Fri Sep 13 14:22:37 EDT 2002 | davef
If that's the case, it's most likely the radio is bad. Again, I'm not clear, but it sounds like using the MD is the trigger to shut the player down: * Stop using the MD. * Fix the MD or some of the associated power supply regulation circuitry. For
Electronics Forum | Thu Nov 24 01:21:42 EST 2022 | crystalw4280
The bottom piece of the sensor broke, and it threw it off, fixed now. Wasn't sure, it must have come loose enough to throw it off, but not enough to trigger an error that it wasn't working...because it was still in the casing
Electronics Forum | Fri Jun 12 08:37:21 EDT 2015 | cgreiner
Check to insure that cut outs in the PCB is not triggering the board sensor on the input of the unit. We had a few boards where the cutout in the board was seen as the end of the board and it would stop several inches from the board stop. We ended
Electronics Forum | Thu Feb 28 08:58:02 EST 2008 | adlsmt
We actually ran production boards on Mydata and Universal Advantis. The Mydata machines software was very command line oriented which I thought was strange but they said they had no intention of upgrading it. The Mydata placement accuracy was superb.
Electronics Forum | Tue Oct 20 10:31:50 EDT 2009 | lloyd
Seth, From the Siemens technical information document: Raceway monitoring detects incorrect positioning of the Z axis with respect to the raceway during motion of the star. This is done by monitoring the current drawn by the Z axis while the star i
Electronics Forum | Tue Nov 15 23:03:07 EST 2011 | supse
Hi I have a problem with one of our MY12 machines, the machine stops very often (approx. 10-20 times a day) writing the following error message : f-mot-msetdyn hydra theta/205(f-hrdw-3). We then have to reinitialize the machine to continue productio
Electronics Forum | Mon Sep 20 22:17:04 EDT 2021 | ttheis
SOLVED Upon manually activating the zaxis to drive the spindles down, it was noted that the touch down sensor for spindle #2 was activating at a certain point in the travel without touching anything. I went to look at the adjustment of the sensor
Electronics Forum | Fri Sep 27 15:14:04 EDT 2019 | dilogic
Just one more thought - we had an issue with +12V supply for VME rack. One tantalum cap in the DC/DC converter module for linear encoder interpolator shorted it out, but oddly enough - not always. We ended up hooking scope to all PSU voltages and whe
Electronics Forum | Wed Sep 04 10:10:10 EDT 2019 | jameshoward
I know exactly what your problem is as I have seen it many times. Your problem is with indexer 1 (the cylinder which runs up and down and actuates feeders on side 1). At each end of the travel of the indexer is a micro switch hidden down below the be
| 1 |
