Electronics Forum | Mon Nov 21 15:52:21 EST 2022 | crystalw4280
The internal conveyor stopped working...won't take board in. Says there is a board inside machine...is it a sensor problem? Any suggestions? Nothing led up to this. Just started machine up after weekend, and it will not take the board in.
Electronics Forum | Wed Nov 23 19:24:04 EST 2022 | proceng1
Is there an IO screen so you can see what sensors are tripped?
Electronics Forum | Wed Nov 23 19:08:20 EST 2022 | leeg
You should be able to check the sensor, most had have the red light to indicate that a PCB is being detected. Depending on the version of software it should tell you within the manual control option too
Electronics Forum | Thu Nov 24 01:21:42 EST 2022 | crystalw4280
The bottom piece of the sensor broke, and it threw it off, fixed now. Wasn't sure, it must have come loose enough to throw it off, but not enough to trigger an error that it wasn't working...because it was still in the casing
Electronics Forum | Wed Jan 19 13:30:37 EST 2011 | bvdb
The user manual says: Cause: A stick feeder part shuttle is in the advanced position where it could interfere with the nozzle. Remedy: Press the [I/O] function key and retract the part shuttle. I don't have a stick feeder. I tried resetting the I
Electronics Forum | Thu Jan 20 07:58:46 EST 2011 | jdengler
Hi Bert, Take all feeders off of the machine. Do a reset start (hold reset switch in while powering up the machine). This will flush the memory so you will need to load PROPER, STATUS, PROGRAM. If it still does it you may have a short in a feede
Electronics Forum | Sun Jan 23 00:57:23 EST 2011 | bvdb
Hi Jerry, Happy New Year. Thanks for your suggestions. You were on the right track because I remembered that one of the last things that happened before the error message started showing up was that I cut and removed the empty tape from the back o
Electronics Forum | Tue Mar 10 11:39:10 EDT 2009 | bobpan
Craig, Try this.... Go into 'machine-calibration-transport' then click on 'touch stop'. Reteach your board touch stop x for both gantries (if you moved both touch stops). If the board still does not reach the touch stop.....teach 'Board Positioning S
Electronics Forum | Wed Mar 28 22:43:24 EDT 2007 | vshan
Hi all anyone can let me know the spring size on the board stop!!
Electronics Forum | Mon Aug 31 11:52:28 EDT 2020 | inspiredmorris20
Hello Jon, I appreciate your reply, correct there are 2 red (24v) that control the main power and 2 blue (they control the power to the units operation keys ready, start, stop, reset, change feeders.) additionally there is a red jumper wire on the E
.gif)
