Electronics Forum | Mon Feb 09 09:00:17 EST 2015 | jax
Outside the MSD issues stated already (and I cannot provide a exact time not knowing multiple factors like Humidity levels, temps, exposure times, etc...) OSP might be the very worst finish to use in this scenario of side 1 / store on a shelf / side
Electronics Forum | Wed Aug 12 11:09:42 EDT 2015 | jvalverde
Hello, I have a problem with the solder paste process, I need a solder paste with no Start-up Time because We do not work 24 hours in the manufacturing process, we works only 8 hours a day and at the finish we need to store the paste in the refr
Electronics Forum | Tue May 10 09:54:35 EDT 2016 | reinhardk
Hi all, kindly asking for some hint with a problem we encounter with our SPI: After inspection, the SPI should show the defect details, but it doesn't. I can see the files created by the realtime-card in the exchange-directory between windows- and
Electronics Forum | Sat Nov 05 20:18:13 EDT 2016 | sarason
I checked the spec sheet and it gives pressure and no volume. The volume on one of my older Yamaha's was about 2.7 CFM. That corresponds roughly to the volume of a small 2HP compressor at your local hardware store. You can place on of these in a smal
Electronics Forum | Thu Jun 15 06:58:54 EDT 2017 | cyber_wolf
Hmmm.... When I clean my stencils after I run a job, it is to clean the paste off the stencil so it doesn't dry out in the apertures and on the stencil surface while it is being stored. Wiping the stencils during production is to clear the paste of
Electronics Forum | Thu Aug 31 16:16:44 EDT 2017 | tschoen
Hello, I have to learn how to program an old MyData (M9) pick and place machine that's been sitting in the company's basement for several years. Unfortunately, I have very little documentation. The machine runs, and there are some programs stored
Electronics Forum | Fri Aug 17 07:04:30 EDT 2018 | buckcho
I agree with you. I just said, if it is customer requirement, factory has to implement it, right? :) Of course it is huge amount of money. SPI is the main control, but it doesnt save you the pressure, speed, snap of from the printer to the trace (us
Electronics Forum | Thu Sep 20 07:18:42 EDT 2018 | proceng1
Has anyone else been experiencing this lately? We have had a rash of boards that come in properly vacuum sealed. We store them in the hot room until we are ready to build, and we get bubbles under the solder mask. We've had 4 different jobs, all di
Electronics Forum | Tue Feb 12 12:47:02 EST 2019 | slthomas
Someone with some more definitive knowledge of these machines will no doubt chime in at some point, but my thought was that the "A-table" is just a data table that stores I/O information. Thus, being "off in A-table YV100X:N2323 YV100XT:n2223" just m
Electronics Forum | Wed Dec 04 04:28:58 EST 2019 | oxygensmd
It seems there isn't right connection between solder and solder-legs. Maybe check that the LEDs get huminidity, have some oxidation on the legs, try different solder paste, check the reflow solder profile. On the photo I can not saw properly reflowe