Electronics Forum | Mon Sep 10 17:52:30 EDT 2001 | mparker
Are you doing actual measurements of the dummy parts placements? or are you just doing a visual go/no go check? If doing actual measurements, be sure to use mil inch units of measure rather than mm. Mil will give you more accurate readings. mm force
Electronics Forum | Fri Sep 06 03:11:31 EDT 2013 | 5pcb
Welcome phone call from all over the world.
Electronics Forum | Fri Sep 06 03:06:18 EDT 2013 | 5pcb
We are a complex pcb supplier in China. We are good at making prototypes and multilayer (8-20)layers PCB. If you think your boards are difficult enough, you can contact me. Let's talk details. sales2@dmele.com Name:Lily Tel:0086-0755-23006293.
Electronics Forum | Thu Feb 13 19:08:31 EST 2014 | darby
Have to agree with Sr Tech and Spoilt - you'd have to really mistreat your paste these days for it to be the root cause. However, try another paste to eliminate that; making sure you abide by the suppliers specs. Pad design, stencil design,(includin
Electronics Forum | Tue Feb 11 12:44:32 EST 2014 | cyber_wolf
Jigo, We have never had a need to do internal testing on solder paste, and your paste supplier should be able to tell you what the correct operating temperature range is. All of the big names in solder paste have tight quality control and I suspect t
Electronics Forum | Thu Jul 26 01:48:51 EDT 2018 | teresat2
How to select high quality PCB circuit board manufacturers？ There are many kinds of PCB circuit boards, and many kinds of high-end technical support are needed in the process and production research and development. In order to know whether the produ
Electronics Forum | Tue Jul 08 06:00:29 EDT 2003 | iman
As part of our process/quality improvement review, it was raised thru' our findings that its a good mfg practice to monitor the incoming solder paste quality (as part of the indirect materials). We get one-page "outgoing QC" vendor reports with each
Electronics Forum | Sun Aug 08 11:15:32 EDT 1999 | Earl Moon
| | Mike, | | | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no goo
Electronics Forum | Mon Jun 27 03:32:52 EDT 2011 | samsim
It will not easy to measure solderability on PCB pad. Any metal tends to oxidize with time and temperature. Make sure your storage of the PCB is accordance to supplier recommended specification.
Electronics Forum | Fri Jun 24 09:32:53 EDT 2011 | kahrpr
Looking at the appearance of pads and solder joint is pretty subjective. Especially lead free people are all over the map on the physical appearance of pads and joints. The true test is solderabilty testing, weather it’s just looking for good wetti
