Electronics Forum | Tue Sep 05 06:23:19 EDT 2006 | jonatf
Hi guys, I want to improve the set up of our printing machine(EKRA) especially on a 0.5mm thickness double sided boards.I find the support pins very time consuming.. any advice?? thanks.
Electronics Forum | Wed Sep 06 13:43:59 EDT 2006 | pr
Me tinks.. pr
Electronics Forum | Wed Sep 06 21:32:41 EDT 2006 | kingdingaling
how much is it?
Electronics Forum | Wed Sep 06 06:12:57 EDT 2006 | jonatf
thanks CL, Any idea how much the Gridlock tooling pin is? Brand new or seconds??? cheers!
Electronics Forum | Wed Sep 06 06:57:39 EDT 2006 | pavel_murtishev
Good afternoon, Check this out: http://www.novatec-eap.com/technology/vacunest.htm Can be a good solution. BR, Pavel
Electronics Forum | Thu Sep 07 01:01:28 EDT 2006 | pavel_murtishev
Good morning, I am not a sales representative, unfortunately. Ask Novatec the quote. BR, Pavel
Electronics Forum | Tue Sep 05 09:54:33 EDT 2006 | slthomas
We had the same problem with our E5. I had the shop make us a template for each two-sided board out of some 1/16" acrylic. The template had cutouts in it to drop the pins through where the bottom side parts weren't. Seemed to work fairly well, no com
Electronics Forum | Wed Sep 06 03:53:49 EDT 2006 | dougs
we do a similar thing but make the template from paper, we just print out an image from the gerbers (to size) showing both sides in different colours, we set this down on the table (had to work out first where the correct position was) then we place
Electronics Forum | Wed Sep 20 15:56:44 EDT 2006 | Rapid
There is a quick change dedicated tooling solution. It involves a "h-tower" and a machined vacuum (or non-vacuum) plate. There are two 8mm threaded holes on the table that are there for support tooling interface. The tower or tooling bolts to thos
Electronics Forum | Tue Sep 05 08:40:33 EDT 2006 | CL
SMAINTECH, Good Morning, We have installed the Gridlock tooling pin with stealth mode on our DEK's. It is a hard tooling pin array that resets the height if the pin for every board. The pin comes up until it comes into contact with something then lo