Electronics Forum | Tue May 15 11:55:16 EDT 2001 | dason_c
We had a same problem before and Cirtech work with FAB supplier. It is due to the contamination on the tank. No special profile and paste use on the immersion tin board. Dason
Electronics Forum | Thu Aug 12 20:32:44 EDT 2004 | usdigital
Indy, We use Palladium silver surface finish parts for silver epoxy attached parts only. It is our understanding that this finish is not for solder, but only silver epoxy attach. I expect that is you problem. Dave
Electronics Forum | Fri Jun 12 21:36:04 EDT 2020 | SMTA-Josh
Has anyone had an issue with changing from a HASL surface finish to a LF HASL finish if it is still being used in a leaded process? Also we are having issues with the planarity on the fiducials with the HASL finish. Are there any suggestions or ch
Electronics Forum | Sun Jul 04 19:49:05 EDT 2004 | indy
Hello Everyone, We are having some problem with Palladium-Silver surface finish. We have ceramic components with the above surface finish. When we try to assemble these on Sn/Pb solder, we are observing open joints. If we reflow the compt for more t
Electronics Forum | Fri Sep 06 17:21:24 EDT 2013 | rodcr
Why do PCB traces need a surface finish? On microstrip (top/bottom) the solder mask does not help
Electronics Forum | Mon Sep 09 21:54:01 EDT 2013 | mandysmile
Hi, rod, The exposed copper area you could do with ENIG. It is with good solderability.
Electronics Forum | Tue Aug 24 13:45:17 EDT 2004 | Indy
Hi, I am trying to assemble a LTCC component with Pd/Ag surface finish on to Sn/Pb/Ag solder and Sn/Ag/Cu solder. I am passing it through a reflow. I have observed poor wettability at the solder-pad joint. Does anyone have information regarding th
Electronics Forum | Tue Aug 24 13:47:14 EDT 2004 | Indy
Hi, I am trying to assemble a LTCC component with Pd/Ag surface finish on to Sn/Pb/Ag solder and Sn/Ag/Cu solder. I am passing it through a reflow. I have observed poor wettability at the solder-pad joint. Does anyone have information regarding th
Electronics Forum | Tue Aug 24 13:47:16 EDT 2004 | Indy
Hi, I am trying to assemble a LTCC component with Pd/Ag surface finish on to Sn/Pb/Ag solder and Sn/Ag/Cu solder. I am passing it through a reflow. I have observed poor wettability at the solder-pad joint. Does anyone have information regarding th
Electronics Forum | Mon Jun 15 16:51:05 EDT 2020 | emeto
Tin/Lead has 183C melting point and probably around 220 peak temperature at reflow. Tin has 232C melting point. I would assume that based on this information you would understand why intermetallic joint is questionable. Go to any flat finish. HASL wi
The SMTA membership is a network of professionals who build skills, share practical experience and develop solutions in electronic assembly technologies and related business operations.
Training Provider / Events Organizer / Association / Non-Profit
6600 City W Pkwy
Eden Prairie, MN USA
Phone: 952-920-7682
