Electronics Forum: surge (Page 1 of 4)

shut down for storms

Electronics Forum | Sat May 14 13:07:42 EDT 2005 | gc

We have surge suppressors on every machine we have as well as suppression on the mains coming in the building. The power in the area has always had too much noise and we did have losses due to surges during storms and such. Three phase surge suppre

Surge Protection for Surface Mount Equipment

Electronics Forum | Wed Jan 04 08:56:57 EST 2006 | james

In recent years we always seem to have problems with machines going down due to thunderstorms. I am trying to find a way to surge protect our Tyco equipment, anyone out there have any suggestions. It would be greatly appreciated.

DEK 265

Electronics Forum | Fri May 21 08:11:54 EDT 2004 | Chunks

Check the surge protector on top of the power supply. Pretty common problem on the 265s.

Dek 265

Electronics Forum | Fri Nov 04 07:20:27 EST 2005 | chunks

By-pass the surge protector on top of the power supply. Located at the bottom of the machine. Pretty common on older 265s.

Surge Protection for Surface Mount Equipment

Electronics Forum | Wed Jan 04 09:44:11 EST 2006 | PWH

Try looking at "Fortress" or "APC" uninteruptable power supplies (UPS).

Surge Protection for Surface Mount Equipment

Electronics Forum | Wed Jan 04 10:52:25 EST 2006 | james

Thanks I have a call into Tyco, hopefully they can help.

Surge Protection for Surface Mount Equipment

Electronics Forum | Wed Jan 04 10:50:23 EST 2006 | bobpan

If the equipment was originally 'quad'....then....they had already had some spec'd out for each machine. I would try calling them and seeing if they still have the 'old' documentation. If that doesn't work....you could try any reputable company that

Fuji IP-1 hesitates for a few seconds then continues working

Electronics Forum | Fri Mar 23 03:53:44 EDT 2007 | Guest

Hi Bert , I dont know much about IP , since I partnered our Fuji CP 6 with Siemens .At any rate, can you check your flat ribbon cable of your Ip's Head. I assume there one wire that is nearly breaking. During movement, head servo controller experie

Surge Protection for Surface Mount Equipment

Electronics Forum | Thu Jan 05 13:40:38 EST 2006 | jax

Remember that there is a difference between protecting the Interface Computer and the Machine itself. One is reletively cheap, one is NOT.

DEK 265GSX Problem

Electronics Forum | Sun May 02 14:37:06 EDT 2010 | dekhead

Something is surging on the 5V line tripping overcurrent on PSU2... If you've got autoflex on the machine the Y15 is th most likely culprit... I've also seen it with the Y2. www.dekhead.com

  1 2 3 4 Next

surge searches for Companies, Equipment, Machines, Suppliers & Information

SMT spare parts - Qinyi Electronics

Reflow Soldering 101 Training Course
Selective soldering solutions with Jade soldering machine

Wave Soldering 101 Training Course
Equipment Auction Automotive Electronics Supplier - Closure of Tier-One SMT Dvision: (10) ASM & Universal SMT Lines & Feeders Equipment as-new-as 2019! Dek | Koh Young | Speedline | Vitronics | Viscom

Best Reflow Oven
Pillarhouse USA for handload Selective Soldering Needs

Training online, at your facility, or at one of our worldwide training centers"
PCB Depanelizers

Low-cost, self-paced, online training on electronics manufacturing fundamentals