Electronics Forum | Mon May 17 10:43:53 EDT 2010 | jaimebc
We are looking into adding an Uninterrupted Power Supply to our MYdata's pick and place, to protect the PC from power surges. I am looking for recomendations from current users. Thanks in advance.
Electronics Forum | Thu Apr 24 09:41:55 EDT 2003 | caldon
You may want to contact Cookson Electronics as they are leading the surge on "LEAD FREE" You may want to post your question to Chyrs Shea at Alpha Metals (Cookson). cshea@cooksonelectronics.com She should be able to field your question and put you i
Electronics Forum | Wed Jul 16 10:55:08 EDT 2003 | stepheno
You might want to check your input power. It is never "clean" but you might have too many spikes and transients. I've seen line monitors used and it was an eye opener how much noise there was on the input power. If you had a CPU go, you might want
Electronics Forum | Wed May 11 11:21:11 EDT 2005 | russ
Been getting wacked by lightning for twenty years in this business. (three times yesterday as a matter of fact) We have never shut down in anticipation that we are going to get hit. I have lost one motherboard in all of these years that cost about $
Electronics Forum | Tue Jun 06 12:19:06 EDT 2006 | Rob
Hi John, They may still read the correct value initially, but they are not going to age well if the electrodes start oxidising. Also the high voltage surge performance & the impedance are likely to be effected, however these may be unimportant to y
Electronics Forum | Mon Apr 26 09:54:59 EDT 2010 | baildl632
What type of wave machine? Does your machine have a pump speed dial? Does your machine have the ability to raise and lower the pot? Raise pot to as close as possible to the pallets/boards and make sure they can pass over the nozzle without hanging o
Electronics Forum | Thu Jun 14 13:49:04 EDT 2012 | rodrigo
Hi all, We have two Heller ovens, a 1700SX and a 1700D. The 1700SX has the profiles made so when you load them the zones turn on in sequence. First zone top and bottom are on when the profile is loaded then the next (top and bot) start to turn on as
Electronics Forum | Mon Aug 19 15:21:17 EDT 2013 | marcelorotofrance
Hi Rollon, thanks for your answer. At this point it seems that cold-start current surge, because the presence of large value capacitors in the power source, exceeds the sensitivity of the protection switches rather than a malfunction. Nevertheless, i
Electronics Forum | Wed Aug 11 23:55:19 EDT 1999 | Dean
| | I appreciate you're input on this, John, Scott. It's a neat thing Mydata did with the power out, status saved feature. That comes in handy a lot down here. | The problem is with our machine, however, "I think", is that we have one of our phases
Electronics Forum | Tue Aug 10 08:51:32 EDT 1999 | Dewey
I appreciate you're input on this, John, Scott. It's a neat thing Mydata did with the power out, status saved feature. That comes in handy a lot down here. The problem is with our machine, however, "I think", is that we have one of our phases go out