Electronics Forum | Tue Feb 16 14:40:54 EST 1999 | john hearty
Has anyone changed out the old 4400 vision processor on a Fuji IP3 and replaced it with a newer 4800 vision processor. What does it take to do this and what does it consist of doing. What do I need to order from Fuji in order to do this.
Electronics Forum | Tue Aug 03 06:14:18 EDT 2021 | bukas
if blade swapping gives same result try swapping the pressure sensors.
Electronics Forum | Fri May 01 16:04:17 EDT 2009 | jimmyboz
I found your ealier thread, when you swapped amps for trouble-shooting, as a rule of thumb, always swap them back, otherwise, you may introduce a new unexperienced problem. The original problem, (Z2 according to the thread) will not influence H1 unl
Electronics Forum | Wed May 19 17:54:41 EDT 2010 | gregcr
I have had problems corrected by swapping or replacing the power supplies in the box. Do you have a second GSM that runs the AIS3500 box? If so swap the power supply and see if the problem follows the swap. I have replaced the supplies inside the
Electronics Forum | Thu Aug 12 15:39:36 EDT 2021 | bukas
it can be cable. can you swap cables with next driver? also swap cables on head. if same driver shows error you need new driver probably. if new driver shows error then its cables or motor. check documentation to see what motor it drives. you cant sw
Electronics Forum | Mon Mar 14 10:42:23 EST 2005 | ???
oh....bye the way....there are dip switches on the driver cards that need set correctly when swapping them.....i hope you set the correct switches when swapping or you probably will never get it to work.
Electronics Forum | Thu Jul 24 11:02:29 EDT 2008 | markhoch
Try swapping the MOT card. Just be sure not to swap with the X-Axis card.
Electronics Forum | Mon Feb 24 14:32:57 EST 2014 | navworx
Thanks Bobpan, It was the theta amp; swapped it to the other side and that side then failed. It would only do it once the unit ran for about 30 minutes. But when it happened, it stayed broken. Swapped out with a refurb from ppm.
Electronics Forum | Tue Jun 30 10:04:44 EDT 2015 | robie69
In the process of troubleshooting I swapped the video cables around and saw the issue resolve itself. I'm guessing it was loose connections. the fact that these cameras all take the same inputs make troubleshooting simple, swap the cable and see if t
Electronics Forum | Sat Dec 10 22:31:16 EST 2016 | ecogroup
Hi Tom, We have a Paragon 150 with the FCU board problem. We are thinking about finding another board and swapping it . Did you get the ROM chips from BTU when you swapped the FCU board? Appreciate any advice. Thank you. Ray
