Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Wed Jul 09 05:06:52 EDT 2014 | bobpan
Are you sure you don't have a door interlock problem? Some of the covers of mirae machines have a physical switch and a magnetic switch that both have to be made for the interlock to be closed. It could be if you have a magnetic switch that the magne
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
Electronics Forum | Fri Aug 30 15:44:51 EDT 2019 | valentink
I will try outline Theta and Z-axis servo issues, we were facing last time. Story behind. Our 750 is used seldom and last time after switching it on initialization procedure ends with T axis of right head: Servo alarm. Opening front cover of 750 two
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Thu May 04 15:32:21 EDT 2017 | dilogic
On the HP Servo panel there are LED's that indicate state of limit switches - so you can see if the problem is in the switch or somewhere else. Did you check it?
Electronics Forum | Thu Nov 04 06:46:19 EDT 2010 | adriana
We find the problem on Servo Pack for F theta axis .The component QM20TD-H Mediu power Switching is damaged! Many thanks!
Electronics Forum | Mon Jan 28 13:58:41 EST 2019 | oxygensmd
1. switch the axis cards 2. switch the axis servo cards 3. make sure the distance between scale and encoder is 400um 4. check the signal by oscilloscope, adjust to have the right signal 5. replace the scale or encoder
Electronics Forum | Thu May 05 13:25:04 EDT 2016 | donpito
check the cards in the VME and also the exchange and nothing happened . check the configuration of the servo beam 1 x1 and x2 Bean 2 and are working well , switch harnesses x1 and x2 and now fails BEAM 1 x1