Electronics Forum | Mon Apr 29 14:36:26 EDT 2013 | bandjwet
I am trying to determine who out there is reballing devices below 0.4mm in pitch. We have been reballing as small as a 4-balled 0.15mm 4 mil ball diameter area array devices using an adhesive-backed reballing preform. 1. For such small devices we h
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Fri Jun 14 13:43:02 EDT 2013 | rway
The low value will be 0.624uF. You have to factor it from the low tolerance (-10%). So: 0.9 x 0.92 (machine tolerance) x 0.91 x 0.91 x 0.91 (3 decade aging factor for X7R dielectric). We factor hours at the 3rd decade (10,000 hours), but you can
Electronics Forum | Wed Jul 03 09:13:23 EDT 2013 | dontfeedphils
I currently run the HLC software suite with a 750/760 line and another 2060 line. For the 750/760 line I have to stick with the older HLC, version 4.5 I believe, which I actually run inside of a Windows 98 virtual PC using a dongle emulator. The 20
Electronics Forum | Fri Jul 19 16:27:38 EDT 2013 | microaide
I think I have the vision problems figured out. There were two problems. 1) The Alignment type was set to "Small" for my TQFP48 part. It should have been set to "Complete". This is a clear case of poor documentation. The AutoProgram manual lists the
Electronics Forum | Fri Jul 19 10:19:01 EDT 2013 | rway
We have inline reworkers, so this time has been factored in. We currently use Siemens S25/20 machines with M1 systems. The placement machines run a little slower than the AOI at times so there is time to perform review, most of the time. It's not
Electronics Forum | Wed Aug 14 10:44:04 EDT 2013 | sarason
In my limited experience. A Domestic Dishwasher with no water recycling like which is offered on some of the newer high priced models works a treat. Clearly this is batch. Inline filtering of the water supply is a good ideal. There are several ways o
Electronics Forum | Thu Oct 17 17:29:46 EDT 2013 | lordofpiggies
Hello. We are building a CCA which has a silicone-based adhesive whose purpose is to bond the bottoms of multiple LED displays to heat sinks. Our customer wants the CCA to be tested for ionic residues per J-STD-001, but we are hesitant to test the
Electronics Forum | Mon Jan 20 11:11:24 EST 2014 | fnorradd
I have an Ersa Versaflow selective solder machine (single bath) which runs via a Profibus control system. I have checked all of the settings on the inverter, and all of the connections and outputs throughout the machine, but the machine returns a 68
Electronics Forum | Mon Feb 10 17:04:35 EST 2014 | globalpowerproducts
I am having a problem producing clean boards when i run them through my new machine. Currently i use an Electrovert system that uses trays and we are trying to upgrade our equipment so I bought a SHEO 8250 and it is making the boards dirty and lots o