Electronics Forum | Wed Apr 30 09:13:30 EDT 2003 | pjc
Yes, there is a limitation with Transmission X-ray on double-side SMT boards, ie.: back-to-back solder joints, components on bttom side over a solder joint.
Electronics Forum | Fri Mar 22 14:34:16 EDT 2024 | carl_p
Used a Gen 3 system for screens & boards. TDC for inline washing.
Electronics Forum | Tue Jul 01 12:34:48 EDT 2008 | glenda
Is there anyone that can send me inforamtion on companys that sale Printed circuit board wash systems?
Electronics Forum | Tue Feb 28 14:49:48 EST 2006 | vdizzle
Yep Grid-Lok sucks for thin boards. We have it set up in 4 Dek Horizon 01s. Grid-Lok is actually strong enough to snap really thin boards. Other than that, the system has been great, especially if you have to do 10-12 changeovers per line per shif
Electronics Forum | Tue Feb 28 11:15:20 EST 2006 | billyd
In my last life we had pretty good luck with the Grid-lok system. Just not very good for extremely large boards, or very thin ones. (Tends to push thin ones up and bend them before the table rises. **On DEK printers, mind you) Form-flex was a nightma
Electronics Forum | Wed Feb 15 21:18:03 EST 2006 | Spilly McNugglets
It's cumbersome. Also if it catches a part partially after initial set-up, you'll get missprints. We had one and caused about 15% missprints. Once removed and hard pin in place, no missprints. Defeats vacuum board hold down too, from all of it's
Electronics Forum | Tue Feb 28 11:07:41 EST 2006 | Chunks
Gel Flex works for Dek, just a slight modificaion. Works 100% better than any Grid type of system. We had missprints from Grid Lok and Form Flex - about every 5th or 6th board. Until we modified the Gels, we would take the time and some peelable s
Electronics Forum | Thu Nov 30 11:10:36 EST 2000 | DL
Can anyone point me in the direction of where to find some lead placement equipment. Currently we have Clip leads that come in reels with solder pre attached are currently done by hand. surface mountable leads/connectors will not do, due to board/end
Electronics Forum | Wed Feb 15 19:34:05 EST 2006 | Sang Jun Kim
Ran across this at APEX Show in California, seems like it has good potintial for supporting PCB Boards good. We are assigned project to find solution to support PCB. Anybody have exerpeince with this?
Electronics Forum | Wed Aug 04 10:20:13 EDT 2004 | santech
I am looking for an inexpensive way to mark pcb's. Anyone out there got any ideas? I need to print out 2-5 characters on an array of 40-60 boards. currently using silk screens and an old screen printer, but I can see that in no time I will have ov
winsouce.jpg)
