Electronics Forum | Sun Jan 02 11:41:54 EST 2011 | ev
First we get a "transducers out of sync" error which can be corrected when we go to the "reinitialize hardware" option in the Utilities menu. However, when it fails to initialize the error is "Xfan not working".
Electronics Forum | Mon Jan 03 09:39:34 EST 2011 | dyoungquist
We have gotten various errors that I have had to troubleshoot over the years. However, I have not seen an "Xfan not working" error. I do not know what would be causing that. Sorry.
Electronics Forum | Thu Dec 30 16:41:48 EST 2010 | dyoungquist
Hi Ev, We are running a TP9-2 which should be very similar to your TP11-UFP. I need a little more information to be able to help. Is it failing on the initialize hardware step? Or is it a different point in the start up sequence that it fails? Wha
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Wed Jul 17 12:00:27 EDT 2019 | weglimir
Hello, Dek printer is starting successfully until "press System switch to initialize printer" but nothing happens when I press the button. What could be the reason? I've tried another pait of monitors with different system button, and it doesn't ch
Electronics Forum | Wed Feb 15 21:18:03 EST 2006 | Spilly McNugglets
It's cumbersome. Also if it catches a part partially after initial set-up, you'll get missprints. We had one and caused about 15% missprints. Once removed and hard pin in place, no missprints. Defeats vacuum board hold down too, from all of it's
Electronics Forum | Mon Mar 03 16:36:51 EST 2003 | gregcr
I have a GSM that has a problem with the 3500EX vision box. The box has a AISI part number #700-3571-1 on it. Does anyone know who makes this? or if it is possible to service this item? I have replaced all the batteries already but there is a comm
Electronics Forum | Sun Mar 12 22:02:40 EST 2006 | Steveo
Personally I think Grid lok is inferior to the new Vacunest system, especially in screen printing. Vacunest is basically a bean bag that conforms to the shape of the PCB and then holds this shape indefinatley under vacuum, until the vacuum is releas
Electronics Forum | Fri Sep 27 15:37:05 EDT 2013 | tuxlab
We are thinking of getting a small pcb assembly setup for a small manufacturing co-op here in Los Angeles. Our experience consist of manual soldering of through hole and smt components. A quick search suggests that there are a few turn key opt
.gif)