Electronics Forum | Thu Jun 10 15:01:24 EDT 1999 | Earl Moon
CP4-3 AND IP3 | >CP4-3 AND IP2 | >CP4-3 AND IP3 | >CP4-3 AND IP2 | >CP3 AND IP2 | >CP3 AND IP2 | Question: | Looking for anyone who has this type of mix, equipment and what is your OEE and how do you come up with the numbers. | | I use Unicam Line m
Electronics Forum | Wed Jun 09 15:03:53 EDT 1999 | Earl Moon
| In past PCB designs I have cleared all traces from all layers | (except pwr/gnd) from fiducial area. It has come to my attention that this is only necessary on the side where fud is placed. Which is the correct method of design using a fidicial?
Electronics Forum | Wed Apr 28 22:16:51 EDT 1999 | Steve Gregory
| Hi everyone, | We started our first machine placed shield test today.We will be machine placing shields with in the next two months. I used a Fuji Qp242 today. There were no problems with pickup etc,. just vision errors. I'm sure we will work the
Electronics Forum | Wed Apr 21 18:06:11 EDT 1999 | Cunli
| I would like to protect my SMTNet e-mail account from others who use my system. I can't seem to find the pass word feature. Although I do incurage going to the site on my system I don't like the idea that everyone can go through my e-mail. Jeff,
Electronics Forum | Fri Apr 09 12:46:10 EDT 1999 | Bob Barr
I have been using an Air-Vac DRS-22 for almost two years with very good results. Once a profile is developed it is very repeatable. The DRS-22 is no longer available, however. It has been replaced by the DRS-24. Unfortunately, the DRS-24 has a lo
Electronics Forum | Wed Apr 07 13:10:36 EDT 1999 | Chrys Shea
| I am getting ready to purchase a spray fluxing system for a no-clean process. I have narrowed it down to the Nordson or Dover system. Does anyone have any experience with either. If so can you relate with me. I am a little leary of the Nordson
Electronics Forum | Wed Apr 07 08:38:33 EDT 1999 | Dave F
| | | I need help in finding solder paste measuring equipment. | | | | | Cuch: What aspect about paste are you trying to measure? | | | | 1 Paste qualification? | | 2 Incoming quality? | | 3 Print volume? | | | | Dave F | | | mostly looking for
Electronics Forum | Wed Feb 24 14:26:24 EST 1999 | Dave F
| Has anyone used the mechanical stencil foil tensioning system from certain company that eliminates using stencil frames and epoxy & mesh? Any comments on whether it's worth looking into? We go through product revisions like we go through clean so
Electronics Forum | Thu Feb 25 18:06:04 EST 1999 | Chris Lampron
| No salesmen please. (I didn't use my real email address) | | I would like to know if anyone is using either of these SMT machines and if they are what input can you give me on them. We are looking at the Contact 3Z and the Multitroniks DHM for o
Electronics Forum | Fri Jan 15 20:37:11 EST 1999 | jason
| | Jason, | | | | Have you looked at Manex software. I know they have a great reputation in the electronics industry since they developed their system around electronics specifically. | | | | Check out this article I found...this may help. Em