Electronics Forum | Thu Jun 19 09:59:29 EDT 2003 | cnotebaert
I dont have Panasonic But I have KME wich is made by panasonic. I have an SP10P there are 2 secret screens i know of. if your system has a touch screen this may work if not sorry. When the system boots up swipe your finger across the top right corner
Electronics Forum | Wed Aug 27 00:01:28 EDT 2003 | Mike Konrad
Danger Will Robinson� Danger! Never mix a post-reflow cleaning system with a raw paste removal application (particularly on an inline cleaning system)!. The paste that comes off a screen contains solder balls that are so small, they will eventuall
Electronics Forum | Tue Jan 11 09:58:18 EST 2005 | jdumont
Well we actually bought a used 3AV system. Been running with no problems at all for a while now. We also already had a 3Z system that has not fared so well. We have replaced both the Y motors, 3 of the 4 Z motors, belts, pulleys, PCB's, spindles...et
Electronics Forum | Fri Feb 06 12:37:58 EST 2004 | stockley
Yaaa...wn...hh...hmmm... Sorry SMTNetfellows I just woke up from my nap. Maybe it's just me but I'm getting a little tired of people badmouthing Contact Systems - so Barney, Bobby, Ron or whatever your name is... quit it... I'm bored with this topic
Electronics Forum | Wed Feb 11 13:46:37 EST 2004 | fatally_phoenix
This company provides third party service for > Contact Systems machines: > > _a class=roll > href="http://www.magellanservice.com/" > target="_blank"_http://www.magellanservice.com/ _/ > a_ ------------------------------ Bob Tomecility at Mag
Electronics Forum | Wed Feb 11 13:54:27 EST 2004 | fatally_phoenix
I don't personally know how to program that machine or diagnose any problems that it may have, but you may want to call Bob Tomelicity over at Magellan. He is a former tech of theirs and we refer all of our clients, that have a Contact Systems machi
Electronics Forum | Tue Feb 17 16:10:21 EST 2004 | pjc
Speedline MPM has recently completed a study on solvents that are available to use in stencil wiper solvent systems. Until now there has been a small number of solvents that have been deemed safe to use. This was due to the fact that a majority of th
Electronics Forum | Fri Mar 19 07:11:31 EST 2004 | pjc
Tyco Automation purchased Multitroniks of Warren NJ, as well as Quad Systems of Horsham PA. Customer Service (U.S. Only) - 800-468-2023 8:00am-8:00pm EST http://www.tycoelectronics.com/cust.stm I believe Tyco Auto has a registration (fee) policy
Electronics Forum | Wed Apr 07 09:43:55 EDT 2004 | Alan
We currently use the bartector system on our CP6. It has saved us quite a few times with wrong part numbers being loaded on the wrong location. (rework for certain parts would have been a nightmare) It is extremely easy to use. I was not involved
Electronics Forum | Wed Apr 28 12:16:09 EDT 2004 | paul_bmc
We usually make a template offline to put with the assembly file. When it is time to run, place the pin support template in the machine, place your pins and your ready to go. Probably about a 15 sec setup. We looked into the ready-e-set pin suppor
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400