Electronics Forum | Tue Jun 14 06:00:59 EDT 2005 | davef
Via email: We also service and support the full line of CR Technology / Photon Dynamics AOI and x-ray systems. If we can assist you with anything, please contact us. Steffan Miller smiller@smt-smis.com 949-212-5991 (C) Surface Mount Inspection S
Electronics Forum | Thu May 05 18:14:11 EDT 2005 | rtorres
Hello we are having a problem with an Unitherm 500 reflow oven from Vitronics. the conveyor is not responding to the system, the speed is out of control, it seems to be alerted. Does any one know what is going on. your help is greatly appreciated. Re
Electronics Forum | Sat May 07 04:28:51 EDT 2005 | grayman
try checking the speed/conveyor driver,encoder,comunication I/O Board system and lastly the program. If the driver is at fault replaced it do not repair it. If software try to load it again but make back up.
Electronics Forum | Sun May 08 08:53:39 EDT 2005 | smtuser1234
Marcel, If I were you I would call Universal and explain what you are trying to do. What are you trying to do ?
Electronics Forum | Fri May 13 14:17:27 EDT 2005 | Jay Salonen
Hello, Does anybody know is there available surface mount leds as bright as You can find at http://www.set-system.com ? See the brightest ones? (superflux types would be ok for me). Thanks in advance
Electronics Forum | Tue May 17 06:14:40 EDT 2005 | aj
John, just finished a similiar project. What is your budget? (very important) what operating system are you running currently? Aj
Electronics Forum | Tue May 31 01:56:25 EDT 2005 | grantp
Hi, We run both, and the Fuji's have a much better vision system, and will place reliably. I would never recommend MYDATA over Fuji, as there is a huge difference in stability and placement accuracy. Regards, Grant
Electronics Forum | Thu May 26 06:59:06 EDT 2005 | CLampron
Good Morning, We have several Mirtec table top machines. We bought the first one when it was under the Samsung name. We had the advantage of doing a side by side comparison with several other systems. The Mirtec was the leader in performance. Since
Electronics Forum | Wed Jun 15 07:44:55 EDT 2005 | davef
Kanban is a paper-based WIP tracking system that is well documented. Here's a paper: http://www.syque.com/quality_tools/tools/Tools59.htm Google to find books and other papers.
Electronics Forum | Tue Jun 21 13:41:39 EDT 2005 | Rob
Hi, What will be the effect in my soldering if my Reflow Oven's Exhaust system is not properly extracting air from the chamber. Recommended is 100 CFM but I am measuring 45 CFM. thanks,
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400