Electronics Forum | Sun Apr 07 00:45:21 EDT 2019 | d_nguyen2018
Hi, Can you show me how to set up tray table? I have 1 x 10 pockets tape with 10 PQFPs. I went into Magazines then selected Tray Wagon. I did first and last part on the 1 x 10 tape pockets but it did not work. I was told that I must set up the tray
Electronics Forum | Mon Aug 03 07:14:38 EDT 2020 | bangir
Hi, How to adjust the table height of Screen Printing EKRA X5? Could you share me the Manual System Operation?
Electronics Forum | Tue Aug 04 04:20:36 EDT 2020 | bangir
Hi Chris, It's arround +/- 2MM. There was a gap if running pcb with thickness 1MM. The PCB position below the rail table.
Electronics Forum | Tue Aug 04 13:45:03 EDT 2020 | oxygensmd
There are one value for thickness during PCB-teach function which is the PCB thickness. The other one is the camera focus in machine option but it is a dangerous function because the camera focus is adjusted by raising/lowering table.
Electronics Forum | Wed Aug 05 07:38:17 EDT 2020 | bangir
Hi Cris, Yes, The PCB thickness is 1mm. the PCB position below the rail thickness when the table go up the print position. Please advice or do you the service manual book.
Electronics Forum | Tue Apr 09 22:19:38 EDT 2019 | d_nguyen2018
Thank you, Alex!
Electronics Forum | Thu Dec 09 13:22:24 EST 2010 | rodrigo
Hi All, I'm trying to use the F4G CP-4 optimizer. I cleared all the issues I was having except for this error I get at the end: Execute, 2030: Cycle Time table file not found I see a file in one of the folders named CP4_CYC.TBL but I'm not sure if
Electronics Forum | Tue Aug 04 01:55:29 EDT 2020 | cbeneat
How much adjustment is needed? Adjusting the snap off will get the PCB tighter/looser to the stencil. But this is only a 3 to -3 MM adjustment.
Electronics Forum | Tue Aug 04 22:26:38 EDT 2020 | cbeneat
So 1MM is the board thickness in your program?
Electronics Forum | Wed Aug 05 06:34:33 EDT 2020 | oxygensmd
Yes if you adjust the thickness to be thin than the machine raise the PCB more to the stencil - than the foil have better tension but it string out faster.
.gif)
.gif)
