Electronics Forum | Thu Oct 08 12:22:05 EDT 1998 | Clifford Peaslee
I found the problem. Netscape doesn't allow copynpaste when a page has a table within another table. I removed the problem (outer table) from the forum messages. But now I must extend the left table (menu) down to accomodate the possibility of long
Electronics Forum | Thu Oct 08 18:50:27 EDT 1998 | dave f
| I found the problem. Netscape doesn't allow copynpaste when a page has a table within another table. | | I removed the problem (outer table) from the forum messages. But now I must extend the left table (menu) down to accomodate the possibility of
Electronics Forum | Tue Apr 19 05:42:13 EDT 2005 | woodglass
There's two sensors at the rear of the XY table. Make sure that these are functioning correctly. You can view their states in the I/O map. The solenoid which actuates the table base up/down air cylinder is also at the rear of the table, to the left o
Electronics Forum | Sat Jan 28 13:28:15 EST 2006 | eeltec
Dear All: I am learning to program a Philips Comet GEM Machine with VIOS. I am programming a simple PCB that has 300 components but just 3 part numbers so I want to build a complete board in each table of the machine (A and B) and until now I have no
Electronics Forum | Thu Jan 04 02:25:12 EST 2007 | Loco
Sorry Dave? There is a seperate table safely hidden away in the D version, but i dont know if it is something new. chapter 7 THT - 7.5.5 Supported holes - solder has a table specifically for PIP, table 7-7 Plated trough holes with component leads -
Electronics Forum | Wed Oct 29 20:58:31 EDT 2008 | rmitchell
Hi, Our Fuji CP6 table is rising up abruptly when it unloads a pcb after populating it. It makes a clunking noise much louder than before. I don't see anything that has changed or gets in the way as far as the table rails lining up with the exit c
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Mon May 14 16:39:38 EDT 2001 | T.F.
Siemens makes feeder hold down brackets for the F5 that does prevent the operator from leaving the feeder in a position that can cause a crash. The brackets attach to the feeder table so you need one bracket per table. The part part number for the b
Electronics Forum | Wed Mar 27 02:59:01 EST 2002 | ianccy
Hi, Don't know if some holes can be drilled to yur machine table, if so, yu can make the support with at least 2 pin and plug into the table, better to use aluminium support, easier to CNC. Hope this help
Electronics Forum | Wed Jun 02 09:21:10 EDT 2004 | James
They take the place of the tooling pins. They magnetically attach to the table. Board comes in, table raises, Red-E-Set supports the board, prints, done. You just have to do the initial setup before running. We bought 4 units for each machine. J
