Electronics Forum | Tue Feb 28 22:32:38 EST 2023 | cbeneat
it looks like the table is in contact with the Y1 switch. If you can remove the cover, the motor is the R/H one. Turning the belt will move that side of the table. I'm going with the assumption that an X4 is close to an X5.
Electronics Forum | Mon Feb 27 22:04:24 EST 2023 | kumarb
Hi. Our X4 is posting the attached error code. In the reference menu, the table dances to align with the SMD stencil and the shuttled PCB. During this activity, hearing some new mechanical ticking sounds that were not hear before. Any suggestions on
Electronics Forum | Thu Mar 11 21:36:51 EST 2010 | davef
Poor man's approach to assessing coplanarity issues: * Get two pieces of 2X4 wood that are the same length, about three inches long * Cut the end of one of the pieces at a 45* angle, so that the 45* angle cut leaves a face on the four inch side of th
Electronics Forum | Tue May 14 18:07:27 EDT 2002 | soupatech
My method is not good if accuracy is an issue. Most of our reels come with a guage on the back. It is not a perfect count but with a good eye you can get within a couple hundred on reels of 5k. On the reels shipped with no guage I usually just hold a
Electronics Forum | Thu Mar 02 19:54:51 EST 2023 | oxygensmd
The question is, the motor is working or not? Moves, does anything? Seems to be endswitch not working if moves and you heard beaming sound - like motor moving but its on mechanical endpoint. If I were you, I bet on a limit switch is defective under
Electronics Forum | Thu Mar 02 20:06:51 EST 2023 | kumarb
Thanks for your comments. The table aligns fine but just makes the whining / ticking sound when using the 'REFERENCE' command. In this command the table moves more than the live 'AUTOMATIC' mode. The motors are working fine to align the PCB & stenci
Electronics Forum | Tue Feb 28 22:45:09 EST 2023 | kumarb
Thanks guys. Chatted with Ekra (Irv / Rudi) and we have nailed it down to the table LEFT side motor and it is specifically the coupler. As I turn the coupler by hand, there is some internal component under the coiled spring that makes a snapping soun
Electronics Forum | Thu Sep 22 18:47:08 EDT 2011 | rodrigo
Hi all, We just got this machine and it is not fully functional. I read somewhere here that the folder mint has some useful stuff. I run mint and it said that it cannot communicate with card 0,1,2,3 (x1,x2,x3,x4). It said to make sure the cards are
Electronics Forum | Sat Feb 12 09:38:39 EST 2005 | primus
I think you may be assuming that our operators aren't already doing that. We need to be able to bypass the interlocks... how do you think our operators make line adjustments? Step the machine, drop the tooling, and eyeball it. That's it. The operator
Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching
| 1 |
