Electronics Forum | Wed Mar 28 10:58:13 EDT 2007 | rlackey
Hi Mark, When we last checked out the laser systems you had to either use a solder preform or apply solder paste to the area, which meant either dispensing or some clever printing. Cheers, Rob.
Electronics Forum | Wed Mar 28 12:46:50 EDT 2007 | realchunks
Rob is right, you do need to dispense paste or pre-forms when using a laser. Although the Panasonic Soft Beam has a wire despenser. I've seen laser soldering and it does work on smaller stuff. Doesn't work well on connectors even after preheating.
Electronics Forum | Thu Jun 22 15:05:55 EDT 2017 | solderingpro
There are several different technologies in the industry today to assist in the out-gassing of flux cores. On automated soldering systems, there are two main types of perforating solder feeders: - Hole Drilling - "V" Scoring By perforating the so
Electronics Forum | Mon May 01 16:37:43 EDT 2017 | solderingpro
Ectimov, Have you looked into table-top robotic soldering solutions? A fraction of the price and offer more long term flexibility. Might I suggest you take a look at: http://www.promationusa.com
Electronics Forum | Tue Oct 31 19:28:24 EDT 2023 | ttheis
We built our own coating system by mounting a Universal Robots UR5 to an edge conveyor between a magazine unloader and magazine loader. The robot has a needle dispenser on the head. We chose a needle dispense process to avoid aerosols and complex ven
Electronics Forum | Thu Apr 30 12:47:54 EDT 2020 | ilavu
I am looking for a software for Janome/Fisnar/Apollo Seiko JR2000(old Model) not JR2000N(new model). It is called "JR Point for Dispensing". It is old model of robot, If anyone have it and can share please? Thanks,
Electronics Forum | Fri May 14 20:21:11 EDT 2021 | bandjwet
Thanks for the reply. We are ramping up using soldering techs and convective hand soldering. We have investigated w/many soldering robot vendors. The number of units is over 100K. We will be automating using a dispense+pick and place for greater c
Electronics Forum | Mon May 24 23:38:17 EDT 2021 | SMTA-64387687
What about dispensing SMT epoxy (cures at much lower temperatures, than solder reflow), p+p components, run through the oven to cure, and using a laser selective solder robot to solder the pads?
Electronics Forum | Sun May 12 21:06:33 EDT 2024 | ttheis
Hot melt dispenser mounted to a cobot. If you don't want to do it by hand, have a robot do it.
Electronics Forum | Thu Apr 26 20:18:45 EDT 2007 | hegemon
For what it is worth, we are purchasing a dispensing system including a Robotic Arm, Positive Displacement Valve (as opposed to volumetric displacement) and Controller. We have purchased this unit for doing lead free 20 mil dots at 30 mil pitch in s
.gif)
