Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM
Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv
Electronics Forum | Tue Oct 26 19:56:54 EDT 2004 | Von S
The Tactile Driver old part # is P3746 and MPM changed it to new part # 1012927
Electronics Forum | Thu Oct 20 13:34:08 EDT 2011 | babe7362000
I checked the housing and it can move up and down freely. I went into Cal and also moved it without a problem. The sensors in the digital I/O seem to be fine. I checked the voltage going to the driver card and it seems to be fine. I think I will s
Electronics Forum | Thu Oct 20 11:39:43 EDT 2011 | swag
Make sure the housing for the switch can move up and down freely (no lose parts/screws and the lead screw is clean and lubed with some light oil). I've had a tactile housing come loose from the lead screw = limit errors - it should be tight with no
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Fri Mar 29 16:17:47 EDT 2013 | aemery
Sorry I am late on this thread, just became a member and was scanning through the posts. I am a former FSE for Speedline, now independant, so all this stuff is my bread and butter. Here are some facts that could help you all in the future. MPM pri
Electronics Forum | Mon May 03 20:17:40 EDT 2004 | Jacek
Try to check axis drivers - at the begining should be tactile. When you press RESET look on the screen - is there any change (position send from encoders) ?
Electronics Forum | Thu Jul 02 17:06:39 EDT 2015 | aemery
Just to clarify, you are talking about the inner black box not driving down and not the pneumatic function that brings the tactile assembly closer to the stencil? Sometimes the pneumatic shafts get slightly bent and the assembly will not retract. T
Electronics Forum | Tue Mar 18 14:29:46 EDT 2008 | chrisgriffin
That AP can paste 0201's and has built in 2D. I would keep it. The AP series "forcers and platens" design is a bit fragile, but reliable and tends to last a long time. My biggest complaint is the cheap air hoses to the 3 forcers. After about 8 ye
Electronics Forum | Mon Jun 19 21:25:47 EDT 2006 | Chris
Try raising the table in Calibrate mode. Sensor or Tactile connector could be contacting the underside of the rails and overloading the axis. Check for 24V on the Z-axis brake. Check the fuse(F5) and voltage to the driver. Check DIP switch settin