Electronics Forum | Thu May 13 23:01:07 EDT 2004 | fastek
Unplug the tactile sensor and check the switch with an ohm meter. If the tactile sensor switch is good go in one of the drawers in the back of the machine and with the help of your schematics find the opto-module that controls the tactile sensor circ
Electronics Forum | Fri Oct 28 06:55:53 EDT 2005 | pavel_murtishev
Hello! I suspect that our MPM AP25 has separation problems (poor stencil � PCB separation). I observe a lot of �dog ears� after print stroke. And this is 100% machine problem, I�m sure. What machine parts should I check first time to avoid separatio
Electronics Forum | Sat Jun 13 13:51:44 EDT 2015 | tnisbet
The problem could be the tactile motor, we have it in stock. Please contact sales@goppm.com and request a quote for part number CA-399.
Electronics Forum | Thu May 13 16:54:55 EDT 2004 | Kuru
I just installed a used Tactile sensor unit, Now it now reads error "Tactile Sensor sensor never closed". If anyone knows or seen this problem pls help. I have adjusted the flag on the photosensor.The photosensor appear to be functioning but the step
Electronics Forum | Tue May 04 16:04:40 EDT 2004 | Kuru
Your are right my trackball was the problem, Now it resets and error on Tactile sensor. If anyone knows where I could get used parts beside MPM, please let know. Thanks
Electronics Forum | Thu Oct 20 13:34:08 EDT 2011 | babe7362000
I checked the housing and it can move up and down freely. I went into Cal and also moved it without a problem. The sensors in the digital I/O seem to be fine. I checked the voltage going to the driver card and it seems to be fine. I think I will s
Electronics Forum | Thu Jul 02 17:06:39 EDT 2015 | aemery
Just to clarify, you are talking about the inner black box not driving down and not the pneumatic function that brings the tactile assembly closer to the stencil? Sometimes the pneumatic shafts get slightly bent and the assembly will not retract. T
Electronics Forum | Wed Jul 13 13:35:07 EDT 2005 | chunks
Maybe you stencil height measurement is being affected. Check your tactile sensor, it may be sticking due to paste or adhesive getting on it.
Electronics Forum | Thu Jul 14 07:59:33 EDT 2005 | james
The tactile sensor seems to be fine. I think it may have something to do with the stencil being not as tight as to one that is on a stainless steel frame. When we set the height of the stencil we have to do it towards the back of the stencil becaus
Electronics Forum | Thu Jul 14 14:57:54 EDT 2005 | pr
I would put the tactile sensor back in the Vacuum nest so operators won't drop it in the paste. my biggest wish, pr
