Electronics Forum | Thu May 13 23:01:07 EDT 2004 | fastek
Unplug the tactile sensor and check the switch with an ohm meter. If the tactile sensor switch is good go in one of the drawers in the back of the machine and with the help of your schematics find the opto-module that controls the tactile sensor circ
Electronics Forum | Thu May 13 16:54:55 EDT 2004 | Kuru
I just installed a used Tactile sensor unit, Now it now reads error "Tactile Sensor sensor never closed". If anyone knows or seen this problem pls help. I have adjusted the flag on the photosensor.The photosensor appear to be functioning but the step
Electronics Forum | Wed Apr 08 10:23:38 EDT 2009 | cyber_wolf
I am assuming this machine has a tactile sensor that mounts to the printing table. If the air connection or any of the wire connectors get under the rear rail it will cause the Z to fall. Also any bare wires on the tactile sensor that touch the prin
Electronics Forum | Fri Mar 18 18:51:59 EST 2005 | valuems
Hello Micheal We are looking for the procedure at this time. And there is no tactile sensor on any SPM made by MPM. The SPM's does not have sensor's on the head either. Any way we will send the procedures and the calibration blocks soon. harry
Electronics Forum | Tue May 04 16:04:40 EDT 2004 | Kuru
Your are right my trackball was the problem, Now it resets and error on Tactile sensor. If anyone knows where I could get used parts beside MPM, please let know. Thanks
Electronics Forum | Mon Jun 14 04:44:15 EDT 2004 | Sam
1. Don't use a PCB for calibration because the tactile sensor have to free to touch the bottom side of stencil. 2. The wiper is option, the function can be disable in the setup menu.
Electronics Forum | Wed Jul 13 13:35:07 EDT 2005 | chunks
Maybe you stencil height measurement is being affected. Check your tactile sensor, it may be sticking due to paste or adhesive getting on it.
Electronics Forum | Thu Jul 14 07:59:33 EDT 2005 | james
The tactile sensor seems to be fine. I think it may have something to do with the stencil being not as tight as to one that is on a stainless steel frame. When we set the height of the stencil we have to do it towards the back of the stencil becaus
Electronics Forum | Thu Jul 14 14:57:54 EDT 2005 | pr
I would put the tactile sensor back in the Vacuum nest so operators won't drop it in the paste. my biggest wish, pr
Electronics Forum | Thu Mar 30 07:44:19 EST 2006 | Chunks
UP 2000 is a good printer. Spares are normal - blades, stencil/board light bulbs, the over head flourecent, get new conveyor belts. Take the cover off the tactile sensor and make sure it's clean also. Other than that it should be a work horse.
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
