Electronics Forum | Fri Dec 30 05:53:32 EST 2005 | JOE
magazine unloader, flat belt conveyor, or a box with some foam inside of it.
Electronics Forum | Sun Jan 01 23:41:21 EST 2006 | KEN
....does a down pillow count?
Electronics Forum | Thu Dec 29 17:21:05 EST 2005 | Larry
We have a Heller 1500W Reflow oven and need a way to catch boards as they come out of the oven. Does anyone have a suggestion as to how to do this. Your reply will be appreciated.
Electronics Forum | Tue Jan 03 08:17:53 EST 2006 | chunks
We have a conveyor then a FIFO in the middle and a conveyor and a Mag loader at the end. If your oven doesn't have SMEMA (like ours) then you need to the conveyor before each. We trick these conveyors by shorting out the in coming SMEMA so they con
Electronics Forum | Sat Mar 20 09:11:10 EST 2004 | Primus
QFP stands for "Quit Fussing with the Paste."
Electronics Forum | Wed Aug 29 10:06:15 EDT 2007 | callckq
H Davef, Ok..Thanks for the input..
Electronics Forum | Thu Mar 11 10:57:07 EST 2004 | russ
I would use a $49.99 hot air gun. The only issue is temp control some have it some don't. If they don't you have to be careful of getting PCB/Componret too hot. It should take about 1.5 min. to get it off. Russ
Electronics Forum | Sun Aug 26 07:13:05 EDT 2007 | callckq
Hi Experts, Understand from my friends, PTH crystal can get damage easily when subject to vibration or heat..For example, if crystal drop from table to floor, its internal part already damage @ crack which cannot be seen by eye. Besides, they als
Electronics Forum | Thu Mar 11 09:50:22 EST 2004 | jpa
Do I need a $6,000 tool to for this or can it be done for less? Thanks for any input!
Electronics Forum | Thu Mar 11 11:27:43 EST 2004 | jpa
Really? A hot air gun? Sounds difficult to control. But $50.00 sounds good! Is this what your company practices? How do you avoid reflowing 603's surrounding the qfp?