Electronics Forum | Mon Mar 16 20:00:47 EST 1998 | Jon Medernach
| Maybe I'm doing something wrong, but it seems to me that The Forum takes a lot longer to open up now. It also takes a lot longer to get back to the main Forum page, after reading an individual message, and hitting the "BACK" button. What's up? Is
Electronics Forum | Thu Jun 14 11:43:52 EDT 2001 | gsmguru
Change times for the Rheo pump are probably a little slower than just swapping blades. You have to hook up the sensors & air lines,remove the bottom cover + charge the pump to get it to operating pressure before you can print. I would guess that if y
Electronics Forum | Fri Feb 11 14:11:51 EST 2000 | jseagle
To be more specific we have a single Contact 3AV that can run the board in question in 5 minutes from placing the board into the machine till the time it comes out. Volume is expected to be low initially but expected to pick up. It just doesn't fe
Electronics Forum | Wed Oct 27 16:16:24 EDT 1999 | John Thorup
Hi Dave I have used the IIT proframe II (I believe the proframe I used four sided tensioning, was somewhat inconvenient to set up and is obsolete) for about six months. I don't have any complaints of note and I do use it to 20 mil. It does take som
Electronics Forum | Wed Apr 12 11:26:53 EDT 2006 | Cmiller
FYI, Chunk is right about the blade detents if you have the Pro-head. If you don't have that head, you will not need them. If you mount your blades using thumb screws, you can stop looking for the detents!! Ours ran very well, keep it CLEAN. We used
Electronics Forum | Wed Aug 09 12:22:11 EDT 2006 | Rob
You are going to struggle with that sort of connector - the only pin headers that seem to have widespread sucess are the dual inline ones with bent over j leads that sit on the board. They come with a plastic hat that allows vacuum pick up. However
Electronics Forum | Thu May 05 01:21:42 EDT 2011 | city4497s
Hi Davef The problem shows up on * random location including component pads * all PCB and different PCB supplier * different solder paste lot * both printing and dispensing process * all production shift * we have only 1 production line It black,
Electronics Forum | Sat Sep 03 13:01:36 EDT 2011 | waveroom
I'm thinking that your soldering irons are not up to the task. take a tip temperature measurement of the iron prior to and during soldering process. With high temp solder alloys you need an iron that provides continuous temperature at the tip. Doing
Electronics Forum | Wed Aug 23 13:37:11 EDT 2000 | Sarry
Does anybody have problem with 8 mm paper component reels?. when feeder indexs component, the tape is not separated form the components completely. soemtimes it takes up the paper from the tape.( I believe it is because of tape has sticky material ).
Electronics Forum | Wed May 24 11:07:24 EDT 2000 | Travis Slaughter
Use a low wattage resistor. It doesn�t take much to dissipate static electricity, but in a emergency hopefully the resistor could act like a fuse, burn up and go open before anyone gets zapped too bad.