Electronics Forum | Mon Nov 27 13:36:24 EST 2006 | cyber_wolf
The fluid heats up to 105-110 from the ultrasonics running, and or from the fluid filtering pumps. The rinse temp is always the same as the wash. It is a single tank with a partition welded in between. (One side rinse, and the other side wash) FYI
Electronics Forum | Thu Aug 10 15:06:03 EDT 2023 | thecolonel97
We tried choking down the water flow to the coolers yesterday just below above the point of where we wouldn't detect flow in the system. This raised the temperature in both coolers for this test. This morning when cleaning the buildup, this had mad
Electronics Forum | Mon Nov 29 11:37:51 EST 1999 | cpitarys
Hello Jason, I will look for the best price and service support to start. Also request an in house trial at the vendor. Jason, are you looking to remove a no clean paste or water soluble paste? Single Chamber Equipment: Most stencil cleaners opera
Electronics Forum | Tue Nov 07 11:51:06 EST 2000 | SPD
Hello John, Some determining criteria. 1. Examine what you are cleaning. Pastes, epoxies, inks, etc. Get the MSDS and samples ready and be prepared to forward them to the manufacturers for testing. They can respond with appropriate system and c
Electronics Forum | Fri Mar 12 18:12:15 EST 1999 | B. Walton
Spray cleaners are poor alternatives to todays ultrasonic stencil cleaners. Ultrasonics are the way to go and you can use rather benign water based chemistries to get the job done. As for screening adhesives and cleaning glue residue with spray wands
Electronics Forum | Wed Feb 01 12:20:16 EST 2006 | cvoyles
Hi Bruno, I am an equipment reseller in business since 1994. I have a Smart Sonic MG3000 ultra sonic stencil cleaner in inventory. It is a stainless steel model with Delta Sonics brand ultra sonic generator. It is the guillotine type that raises a
Electronics Forum | Wed May 22 08:43:40 EDT 2002 | pjc
I have experience cleaning NC for military boards. The reason for cleaning the NC is due to conformal coating requirements. Zestron Vigon A200 and Atron AC 100, as well as Petroferm Hydrex DX have both been effective at cleaning Alpha UP78 NC paste.
Electronics Forum | Wed Jul 11 20:24:00 EDT 2001 | davef
Well, your wipes are a good first step in removing the bulk of the material, but they do little or nothing to remove the material from the apertures. * It would probably be cheaper to use poly stencils and then throw them away after each use, eh? ;
Electronics Forum | Tue May 03 10:57:22 EDT 2005 | Frank R.
We received about 5K assembly boards from china. They left flux residu on top of the board and the flux they use was different than us. RESULT ... we use a translucent cylicon to cover the board and it was not possible to dry the cylicon because of
Electronics Forum | Mon Oct 10 16:02:58 EDT 2005 | pjc
If you don't have a machine, such as from these guys: http://www.pressureproducts.com/SPPC_Hm.htm http://www.smartsonic.com/index2.html http://www.aqueoustech.com/Ultrasonic_Series_Data.htm http://www.emcgti.com/products/product_list.php?cat=8&ca