Electronics Forum | Tue May 17 18:00:47 EDT 2016 | rx8pilot
I spoke with a very pleasant gentleman at Automation Technical Services. We were able to determine that my feeders are not the modified versions that are capable of 2mm pitch. They are only capable of 4mm. They offer a feeder that is the same basic h
Electronics Forum | Thu Oct 14 20:03:18 EDT 1999 | John
Larry, If you are asking about how to package your component in tape and reel, I would contact the 3M company. There are many tape companies out there, but my company has been very happy with 3M. If they don't have a tape that's stock, they'll guide
Electronics Forum | Sat Jul 17 10:04:39 EDT 2004 | stefwitt
I think we should shift this issue to the machine suppliers, requesting changes in the machine design, in order to keep at least the jobs of high mix, low volume in this country. We can only compete with low labor cost countries by increasing the lev
Electronics Forum | Fri Jan 27 10:02:05 EST 2006 | fredc
If your have enough hours on a machine that you have all the windmills off for maintenance, it would seem to be a good thing to check this height. It would take only a few minutes to put a dial indicator in and manually crank the machine to the botto
Electronics Forum | Fri Apr 26 08:38:14 EDT 2002 | ian
We have had Mydata for eight years and Siplace for six. We have found that the Siemens is much more accurate and faster than the Mydata (about four times quicker). Although the Mydata is more friendly regarding the software, if the upfront preparator
Electronics Forum | Sat May 01 10:04:35 EDT 1999 | Bob Willis
| I would like to know if there is any good training for Hand Soldering, Component Identification, Wave Soldering, and so on. | | I have seen two diffenent tapes and they were short and poorly done, I would like to buy some if I knew it had some goo
Electronics Forum | Fri Oct 01 14:06:08 EDT 2004 | russ
after we teach their positions We tape the sticks down. It is also helpful to make sure that you tighten the "discs" that are located on the tension rods. There are available if you desire guides and stops from Samsung that attach directly to the fe
Electronics Forum | Fri Sep 01 22:44:47 EDT 2006 | dmfausti
I have just been engaged again in SMT pick-n-place machines. My latest exposure is with Yamaha YV100 and YM84. I have been having some problem on feeders, especially on 1206 reel packages and above. The plastic cover on the reel does not peel off eas
Electronics Forum | Wed Jul 01 01:25:58 EDT 2020 | jmelson
> I think the main > issue is the bend radius you can apply to tape > with deeper pockets. Right, on my Philips CSM84, on the larger tapes, I don't thread the tape through the return slot, I let it play out the front of the feeder. The
Electronics Forum | Thu Jun 12 17:52:37 EDT 2014 | jorge_quijano
Update 6/12 After solder preform (SAC303 0603) I did not get good result... Couple of connectors have a guide pin that does not allow enough space for preform :( I will try with aperture size modification for my next run. What about step up stenci