Electronics Forum | Fri Jun 16 15:50:08 EDT 2006 | Bert van den Berg
PSA - Pressure Sensitive Adhesive? I don't know which type of tape the affected reels of parts use but it is not sticky. Thanks everyone for the comments and suggestions. There were no missing teeth on the plastic take-up reels. I have cleaned an
Electronics Forum | Thu Apr 23 18:40:35 EDT 2009 | nickh
Do any of you fine people have any suggestions on how to align the Fuji CP3 tape leaf sensor? The little mirrors are out of alignment, any ideas how to get them back? Thanks!
Electronics Forum | Sat Apr 25 02:46:18 EDT 2009 | smellew
FYI SME offers a replacement Tape leaf detection system which covers the whole range of FUJI CP4-CP7 machines.its also very reasonably priced. It doesn't use Fibre Sensors or mirrors. it only has 1 adjustment which is height via Eccentric screw. even
Electronics Forum | Mon Apr 27 11:04:59 EDT 2009 | nickh
Thanks for the help Jerry
Electronics Forum | Fri Feb 13 10:13:56 EST 1998 | Simon Washer
Has anyone running the cp4-3 feeders (MC type) in 8 by 4 td flavour seen excessive wear on the aluminum body caused by the tape leaf cover and tape leaf retaining clip?? These are the black anodised aluminum feeders (new type) that we run on all cp4
Electronics Forum | Mon Oct 22 10:54:48 EDT 2007 | mulder0990
What type of feeder storage carts do you use for your feeders? I have many of the Fuji CP-6 racks, but I have found the few Mossman Tebbs racks mor useful and safer for the feeders. I am constantly fixing damaged tape leaf covers from operators not
Electronics Forum | Thu Mar 01 16:39:29 EST 2012 | triadelectronics
Our company is going to attempt to place 0201 components using our Fuji CP4-3 with the upgraded SMD3 vision system. Count On Tools is providing the 0.4 mm nozzles and we are using our 8mmX2mm feeders with the 0.7mm tape leaf (if it works at all we w
Electronics Forum | Thu May 20 01:53:31 EDT 2004 | alwil
I repair our Fuji feeders myself. They are easy to work on. Most of the issues are usually related to components jammed and general cleaning. Minimum lubrication is required. Tape leafs are inexpensive to replace too. Happy repairing. Cheers.
Electronics Forum | Thu Mar 14 23:20:05 EST 2002 | alanwilson
Missing and misplaced components could be down to board supports set too high or too low. Check the ZO and make sure the deflection is set ok at various points across the board. Check the other usuals such as sticking nozzles, correct size nozzle for
Electronics Forum | Wed Jul 30 11:11:11 EDT 2003 | Roger
Has anyone changed the PD on this part lately. Sounds like a program (PD) issue. Nozzle size should be .7mm. Narrow view should be selected. Tape leaf cover on feeder should be .7mm. Make sure parts aren't on the camera lens. Good luck!
