Electronics Forum | Wed Sep 27 16:54:30 EDT 2000 | LarryK
We currently use Kapton tape to cover a display. The only real purpose for this tape is to cosmetically protect it thoughout the process. The display gets hand soldered and washed, so the idea of the tape being high temperture isn't a factor. Becaus
Electronics Forum | Wed Sep 27 19:57:41 EDT 2000 | Dave F
Our display suppliers provide displays either with: * Molded plastic cover that we recycle to them * Plastic film like the guys that change your oil put on your wind shield to remind you when to get your oil changed.
Electronics Forum | Tue Jan 24 21:15:07 EST 2017 | david_chiu
I have met the same issue before. 1st possible root cause: The dimensions of reel's each chip inserting hole are a little bigger. You need to see if the turn over issue are all happened in the same vendor's reel material. 2nd possible root cause: The
Electronics Forum | Fri Jan 06 22:15:50 EST 2017 | sarason
Looking at your picture. Is this the first component in a reel with no tape header. If so that is your problem. Or is this a piece of cut tape that has been peeled and is sitting between a set of rails? sarason
Electronics Forum | Thu Mar 18 20:08:34 EST 1999 | Steve Gregory
Are you suggesting there may be some chemical incompatibility between paste/flux chemistries and the glue being used - thus intefering with the glue's ability to bond properly? I've only heard of this possibility, but never experienced it. Justin, St
Electronics Forum | Mon Mar 22 18:03:15 EST 1999 | Marc
| | | | | Hi folks, | | | | | | | | | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diamet
Electronics Forum | Sat Aug 18 23:03:07 EDT 2012 | eadthem
We have had this problem in the past, On paper tape resistors(old stock from before i took over and forced rotation on everything) and on embossed (national semi parts, strings of glue pulled back like seat belts across the pocket.) For the national
Electronics Forum | Thu Apr 11 07:13:09 EDT 2002 | Johan Bergstrom
Don't throw away the tapes ! We use vast quantities of component tape while testing our P&Pmachines. And mind you, we are normally not particular on what values the components have. ( For some tests we don't even need components in the tape. Its just
Electronics Forum | Fri Mar 19 12:18:27 EST 2004 | Primus
Isn't it funny, I just experienced that for the first time last night? We're always having tape clutch errors. Glad we're not alone on the Z-axis situation.
Electronics Forum | Fri May 08 15:12:23 EDT 1998 | Ryan Jennens
I am running boards with gold fingers on a pallet for masking purposes. The pallets worked fine for a while but know the gold fingers are getting solder on them. We have tried everythin: new pallets, cleaning the pallet and board to be sure there
