Electronics Forum | Tue Jan 14 11:39:51 EST 2020 | avillaro2020
Thanks Robl. I’ve contacted samtec followed their advice but ended up empty handed. Originally my stencil thickness is 6 mils, samtec stressed the need for the paste and charge to have good contact but this is challenged by the inherent charge non-co
Electronics Forum | Tue Jul 20 15:02:49 EDT 2010 | vetteboy86
I've seen this warp issue across several different PCB's we assemble. One of the biggest head ache's is getting the boards to transfer between machines, converyors, and inside our pick and place. Due to the warpage, transport between conveyors is dif
Electronics Forum | Mon Aug 22 11:50:02 EDT 2011 | rway
Yes, but even high force probes are not a cure-all. You still get flux build-up over time which can cause contact issues. The best way is to use a low residue flux in the wave to minimize what's left on the pcb post-wave.
Electronics Forum | Sun Sep 22 13:14:56 EDT 2002 | scottefiske
Stop the lines...! Stop building defects and rework into your product. Contact Fab Supplier and have pipeline filled for small amount of replacement fabs to keep lines running and limiting production scheduling and impact. Request to have the board
Electronics Forum | Wed Jun 08 13:49:48 EDT 2011 | sonofptolemy
Hello, I am having a problem with HASL PCB's after it comes back from the stuffer. To me it looks like oxidation and it causes poor wetting. This leads to a bunch of problems all of which have different symptoms but the cause is this oxidation proble
Electronics Forum | Fri Aug 29 09:39:08 EDT 2014 | rgduval
I'll try to deal with the issues as you've presented them. 1. Blistering/delamination, shown in photo 2. The most likely cause of blistering/delamination like this is moisture in the boards. The moisture can get into the boards in multiple ways..
Electronics Forum | Wed Feb 02 20:53:34 EST 2000 | Dave F
Dennis: Several points: 1 If you're talking AlphaLevel process (?): � Good solderability, as HASL, even no-cleans bite well. � Planarity, uniform deposit, no bridgin� of FP. � Doesn't store as well as NiAu ... LT 6 months sealed � Very sensitive t
Electronics Forum | Thu Jul 03 03:23:04 EDT 2003 | loz
I have been advised recently about pcb manufacturers, that somehow or other supply pcb's with contamination. Visually they are fine, but problems arise during SMT manufacture, ie solder balling, non-wetting on pads, and also during wave solder proces
Electronics Forum | Fri Sep 17 09:31:17 EDT 2004 | russ
Step stencils are used but only when necessary. One reason to use one would be a PCB with 12 mil pitch and very large coils or something of that nature. The 12 mil pitch part would require a 4 mil thick stencil to ensure release while it would caus
Electronics Forum | Wed May 22 19:10:47 EDT 2013 | anvil1021
We do a lot of these devices and I guess I am not familiar the term "Dry Solder". The QFN device is not designed to have a drain hole, but needs to have thermal vias to control heat in most cases. We have used every possible gnd pad design and modifi
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
