Electronics Forum | Wed Nov 09 05:44:06 EST 2005 | grantp
Hi, It sounds like your vision is not setup right for this component, and it's rejecting some of them because they would be failing the test. This brings up a point we discovered. Don't use auto teach for the component if your using HYDRA or vision
Electronics Forum | Tue Apr 04 10:39:12 EDT 2017 | prdmm1
we have a My9 using 2.4.6B software. the auto teach for new components option is there when creating a new package. but when i select it, it wont work. does this mean i need a software upgrade or does this mean the auto teach was disabled? when i hit
Electronics Forum | Sat Feb 10 04:17:40 EST 2007 | Grant
Hi, I don't know about other peoples experience, but I have decided i absolutely HATE auto teach. The problem is with auto teach you just measure one component, and then you need to open up the tolerance to get an acceptable pass rate. Which means
Electronics Forum | Tue Nov 01 16:09:38 EDT 2022 | kamedatec
The machine had the Auto Tray installed but was removed to put here in the company because the machine was bigger than my elevator. The owner told me it was working, which made me waste time testing all possible settings, electronic cards and cables.
Electronics Forum | Fri Oct 28 02:18:03 EDT 2022 | kamedatec
I bought a YV100XG machine with AutoTC (Automatic Tray Feeder), Everything is working except AutoTC, when I active this function, pops up the error that the Servo Motor LZ1 was not found. I changed the control card of the servo motor, checked the wir
Electronics Forum | Wed Dec 09 17:22:09 EST 2015 | tombstonesmt
I couldn't be more pleased with Panasonic. We've upgraded from MPAV's and MSR's to CM602/DT401 and now their NPM platform. NPM's are extremely fast and accurate. Their auto pickup position teach is great especially if you're running any 0402 2mm pit
Electronics Forum | Tue Apr 12 21:43:50 EDT 2016 | cmarasigan
There is an auto teach of QFP component for CM402 wherein machine can auto recognize number of pins, pin pitch. Just make sure on your part data you have selected the right reference part (Ref: 171)for QFP. For manual component recog; 1. Set Comp si
Electronics Forum | Mon Nov 21 10:56:32 EST 2011 | gosswald
I have been able to get the machine to run by using the teach feature in Central Controller. The fiducials coordinates are there from Auto Program even though they won’t run. Another problem I have with this is the board fails the visual inspection i
Electronics Forum | Tue Apr 02 13:08:40 EDT 2013 | babe7362000
It has been years since I used autoprogram. But I believe your low reference number is your low slot number on the base and then the ref. is what slot you will teach your feeder ref. to the far left. And the High slot number is the higest slot numb
Electronics Forum | Mon Mar 01 01:03:27 EST 2004 | moncav
Hi, This is true if you are using the Grid-lok in the "full auto mode" which sets and resets for every pcb. Ohterwise you can teach the system a flat board (by various techniques) and it will maintain that profile throughout the product run. You sho
winsouce.jpg)
.gif)
