Electronics Forum | Wed Aug 28 18:08:07 EDT 2002 | MikeF
This looks like it may be a good application for an Air-Vac or Wenesco type solder station. It is a solder pot that has a small motor to pump solder up through a chimney. You can put different nozzles on the top of the chimney, so you only apply sold
Electronics Forum | Wed Feb 15 08:47:09 EST 2006 | pjc
Yes, doing the DoEs on your wave to achieve optimum settings that deliver the best results on your worst board is correct method. If not clear on the process, there are still wave solder process classes out there you can attend or hire in-house. If y
| 1 |
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)
