Electronics Forum | Sat May 17 10:38:49 EDT 2014 | sarason
I hate to say this but in all probability this wont work. I have built real strain gages and they depend on the change(Co-effiecent) of resistence with strain(or Stretch). since you are connecting you elements up with copper wire it will frm part of
Electronics Forum | Thu Aug 09 01:18:59 EDT 2018 | grek
Hello, i would like to ask you if it is there some kind of literature where i can find more about Press Fit Technology? I would like to learn more about this technology. I found great literature Einpresstechnik from Mr. Tilman Heinisch. But i would
Electronics Forum | Fri Aug 10 11:20:37 EDT 2018 | horchak
Since your question is general I will be general. The most important thing for press fit connectors is the design, and the proper tooling. Design considerations for the PCB are proper finished hole diameter, type of plating on PCB and connector or pi
Electronics Forum | Mon Jan 07 13:11:56 EST 2008 | chef
might try solder-less through hole connector technology for your SS tabs- the pins are barbed and it is pressed into place.
Electronics Forum | Sat Jan 01 10:41:30 EST 2005 | davef
Is this what you're talking about? http://www.ustreas.gov/press/releases/js703.htm We don't believe the "Technology Investment Incentive Act of 2003" [108th CONGRESS, 1st Session, H. R. 1232: To amend the Internal Revenue Code of 1986 to shorten th
Electronics Forum | Fri Dec 08 23:02:24 EST 2000 | LeeKibler
Beware the foam fluxer. I had a problem with cracked caps that just about drove me off the deep end. I discovered that my foam fluxer air knife was not turned on resulting in excessive flux. The excessive flux (VOC free) was not properly dried off
Electronics Forum | Thu Dec 26 13:02:15 EST 2002 | MA/NY DDave
Hi Again, As I was thinking about this, I remembered another unconventional way that I was told about from one of the starters of this technology. Now I don't think anyone would use this technique anymore, yet here it is: Press Cutting and Pushing
Electronics Forum | Tue Jan 04 16:20:50 EST 2000 | John
My company is considering purchasing a depaneling press from Pioneer-Dietecs. Our initial evaluation has been very positive; however, in a recent meeting a question was raised about the amount of stress induced in the pcb/components during depanel.
Electronics Forum | Tue Dec 17 13:42:04 EST 2002 | robf
There are a few emerging technologies that have been growing in popularity for the past few years. Pin through paste, press fit connectors and selective soldering machines seem to be displacing custom fixtures. Most of the mixed technology boards o
Electronics Forum | Mon Jan 04 23:22:33 EST 1999 | Steve Evers
| Does any one have some information on Sony routing machines? Do you know the website, the contact? Thanks. | As in PCB depaneling? The last two Sony integrated lines I saw were using the new patented Die Cutting depaneling technique, not routers.
