Electronics Forum | Fri Jan 21 11:28:39 EST 2011 | nucleartoast
I worked for Electrovert for 20 years and up till today the 1421 is still the oil of choice. The chain doesn't care who's oven it's running in but it does require regular lubrication.
Electronics Forum | Wed Dec 21 06:51:48 EST 2005 | aj
Hi all, I have an Electrovert Econopak Plus wave solder machine. Lately the solder pot temp has been fluctuating +/-10 degrees c. I have replaced the thermocouple as I suspected it to be faulty but the problem still exists. I am confident that the
Electronics Forum | Tue Aug 22 16:46:31 EDT 2006 | Steve
Using Interflux IF2005, Have electrovert as well as new Novastar Topside of board temp is 265F solder bath 275c. I assume applying via foam fluxer. Not sure.
Electronics Forum | Mon Oct 14 15:48:37 EDT 2002 | pjc
If you are concerned with the actual temp of your pre-heater verses what the machine's display "says" the temp is, use a calibrated digital thermometer and place the thermocouple probe inside the pre-heater and next to the machine's thermocouple for
Electronics Forum | Wed Apr 04 16:54:58 EDT 2007 | pjc
Maybe more baking time is needed. Topside board temp too low. Moisture trapped in board. Top of through hole capped by component and trapping flux. http://www.speedlinetech.com/electrovert/electrovert-troubleshooting/index.htm
Electronics Forum | Wed Jan 26 16:51:18 EST 2000 | Casimir Budzinski
I am using kester 958 no clean in an Electrovert Econopak 2 and having trouble with white residue, the solder pot has a foam fluxer and I have tried diferent setings on the air knife angle & pressure, the top board temp is aprox 200F.Any help would b
Electronics Forum | Sun Mar 07 09:24:55 EST 1999 | Scott Cook
| Hi Ya'll... | it's a Soltec Prisma and the conveyer keeps jamming. What it's doing is up at the exit end where the drive motor is, the chain keeps wrapping itself around the drive sprocket and jamming...this is on the backside rail, the frontside
Electronics Forum | Wed Feb 12 20:13:39 EST 2003 | cmiller
Does anyone have any experience with setting up a nitrogen supply system to a wave solder machine that is equiped for it? Does the nitrogen need to be room temp or higher? Does it make a big difference with bridging or solder quality? We bought a use
Electronics Forum | Fri Feb 22 12:02:24 EST 2008 | soudomphong
I have been searching for a compatible high temp chain oil other than Tribol 1421/SG due to cost cutting, which is what electrovert is recommending. I was wondering if anybody can tell me beside Tribol 1421/SG. What other brand out there that is come
Electronics Forum | Thu Jan 29 12:47:53 EST 1998 | Henry Lee
I have an Electrovert Ultrapak 445 Wavesolder machine with 3 IR preheat zones and a single wave with omega wave. I want to run a DOE (Taguchi) to determine the optimum settings for soldering both single-sided and double-sided boards. Can anyone po
