Electronics Forum | Fri Oct 30 15:09:44 EST 1998 | ChungPark
| Dear all, | | What are your views on reworking BGA's? I mean, with the BGA going through reflow temperatures four times or more, and with a manual reballing process, wouldn't it raise up a few reliability issues? Would you consider not doing rew
Electronics Forum | Thu Jun 08 04:31:24 EDT 2006 | vasily
Hi First I think you have to analize your PCB design. Heavy weight components should be gathered on one side of PCB. As I think, if you want to reflow both sides simultaneously there might be a problem. A chance that large components will drop off
Electronics Forum | Tue Feb 08 04:27:55 EST 2011 | thomas111
hi, I am a Hardware designer . One of my products is undergoing a Reliability test in which a resistor shows a high value on board from its specified value .However it retains the original value when its cooled under room temperature. The resistor
Electronics Forum | Mon Feb 06 17:19:59 EST 2017 | davef
Evtimov: IDEALS Project was one of the first to talk about componebt and board damage caused by LF soldering temperatures. There's lots of more current stuff on the web. Here's some that may help: * Assessment of Long-term Reliability in Lead-free As
Electronics Forum | Sun Jan 30 21:56:05 EST 2000 | Paulvannan
We used Promosol Sn96.5/Ag 3.5 during our initial qualification for similar application. We could not achieve a shiny solder joint. Our changes to Sn95.5/Ag 4.5 does not improve the look. In order to confirm the reliability of the joint, I suggest yo
Electronics Forum | Mon Feb 06 22:38:46 EST 2017 | david_chiu
No matter in selective soldering or wave soldering process, higher pot temperature and longer wetting time can increase IMC thickness and joint strength(reliability), but as Daivf said, you need to care if the DIP component and bare PCB was damaged b
Electronics Forum | Wed Jan 30 06:45:01 EST 2002 | yaq
Hi, Has anyone done some research (measurement/simulation) on the effect of PWB vias on solder ball temperature of the component? Would this have some effect on solder joint reliability especially during power cycling? Any comments will be appreciat
Electronics Forum | Thu Jan 31 04:48:04 EST 2002 | yaq
Hi, Has anyone done some research (measurement/simulation) on the effect of PWB vias on solder ball temperature of the component? Would this have some effect on solder joint reliability especially during power cycling? Any comments will be appreciat
Electronics Forum | Thu Mar 22 16:35:06 EST 2001 | Steve
Deja vu! When I read your response I turned around to see if you standing behind me listening to our problem. We currently make about 50 different boards all using no-clean that have no problems, yet this newest boards has a couple of issues that eng
Electronics Forum | Fri Jan 15 13:35:03 EST 1999 | Terry Burnette
| I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | Thank you, | Wirat
.gif)
