Electronics Forum | Mon Aug 16 11:58:29 EDT 2004 | Dreamsniper
I've worked with a Vapor Phase Oven a semi-automatic and a manual oven for evaluation. They worked fine and produce better grain of solder joints. The fluid that you need depends on the solder temperature that you require. I've used a 200'C fluid for
Electronics Forum | Mon Jun 27 12:02:47 EDT 2022 | proceng1
I have never used a VP oven, but I did get a pretty good demo of one and was pushing hard for my company to acquire one. The issue ended up being that there was not an East Coast distributor for the "juice" and that became cost prohibitive to get sh
Electronics Forum | Fri Jul 28 14:34:13 EDT 2000 | Gary Simbulan
Belive it or not, these boards were run through a Centech batch mode Vapor Phase machine. Single stage top side IR preheat. Vapor temp 218 C. Solder paste is an SN62 RMA.The boards were FR4 8 layer w/ solder mask, fairly conventional as might be e
Electronics Forum | Fri Dec 27 17:18:37 EST 2024 | SMTA-71155914
It sounds like the lower BGA isn’t getting enough heat during the reflow process, likely due to the upper component in the PoP assembly blocking some of the heat. First, double-check the thermal profile to make sure it matches the solder paste specs—
| 1 |
