Electronics Forum | Mon Feb 17 22:05:24 EST 2014 | kahrpr
I am not aware of any correlation that temperature and pressure is a good indicator of board cleanliness. You can drop a thermometer into the tank to verify the temperature. Water cleanness/Ph are more important. If you are truly worried about board
Electronics Forum | Mon Feb 17 03:23:33 EST 2014 | cunningham
Does anyone have a company that can do wash profiler? I want something similar to thermal profilers like your Kik and Datapaq but obviously it needs to be water proof. I want to measure temperature and pressure from the jets as part of a weekly SPC
Electronics Forum | Tue Feb 18 11:02:05 EST 2014 | cunningham
Thanks for the reply. Yes we currently have an Ionagraph setup at the bottom of the wash where we take the first board out for that day and check it for contamination. Im just wanting to get an idea if any jets are blocked and that the temperature
Electronics Forum | Thu Jun 10 21:43:18 EDT 1999 | Dean
| | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like poin
Electronics Forum | Tue Jun 15 16:37:17 EDT 1999 | Philip Kazmierowicz
| | | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like
Electronics Forum | Sat Jun 12 16:45:48 EDT 1999 | JohnW
| | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like po
Electronics Forum | Sat Jun 12 17:41:13 EDT 1999 | JohnW
| | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like po
Electronics Forum | Fri Nov 25 20:57:30 EST 2016 | sarason
You guessed right. Not hot enough to get good reflow. regards sarason
Electronics Forum | Sat Nov 26 00:56:17 EST 2016 | slavek
thank you sarason
Electronics Forum | Fri Nov 25 05:16:44 EST 2016 | slavek
Hello, I want to ask on suitable temperature profile for PCBs with ENIG final surface finish. I know that it is complex question with many unknowns. When the PCB will be standard 1,5 mm 35/35 Cu and the amount of components will have any influence o
