Electronics Forum | Thu Jun 26 05:07:19 EDT 2014 | bobpan
On the older machines if the z-axis has springs on them sometimes they get weak and when you open the door the z will not stay up. Before closing the door manually push the z up if they are dropping down then enable the motor power. If this is the ca
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Fri May 01 22:22:20 EDT 2009 | rodrigo
We didn't leave them swapted. They were placed in the original position until we got the replacement. What has me puzzled is that it worked for one panel correctly. I want to answer the other posts here too ... SA-6 is for Z2 The amp showing 7 is f
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Thu Sep 15 13:55:31 EDT 2022 | jojoled
Hi all, I need help with problem Iam stuck with JUKI KE760L. -SERVO ALARM 1 and ALARM4 https://photos.app.goo.gl/CCDcNtbbEhJLBo47A Sometimes I do get error ON ALL 4 SERVO drivers (1-2seconds after starting the calibration routine (even before the Z
Electronics Forum | Fri Mar 29 09:34:21 EDT 2013 | lkavan
Dear friends, I need to retune servodrivers Panasonic MSD5A3P1EA in my Tenryu MT5530. Some Z axis servo loops are unstable. But I cannot find old Panaterm software for DOS which should be able to communicate with these old drivers. Can you help me? P
Electronics Forum | Sat Jun 22 05:40:36 EDT 2013 | lkavan
Hi friends, I am sorry that I boring you again, but I hope somebody can help me... I have a problem with servodrivers Panasonic MSD5A3P1EA in my Tenryu MT5530. Some servo loops are unstable, motor is shaking. It is problem with driver, when I change
Electronics Forum | Tue Jun 23 08:08:38 EDT 2009 | ptxems
We have a couple of Zeva/Juki PM570L's. One machine has developed a fault with the z axis motor. It is continually 'buzzing', we have checked and there is 24VAC on it. Although even on the other machine there is AC voltage on the motor. We have sw
Electronics Forum | Tue Oct 20 10:31:50 EDT 2009 | lloyd
Seth, From the Siemens technical information document: Raceway monitoring detects incorrect positioning of the Z axis with respect to the raceway during motion of the star. This is done by monitoring the current drawn by the Z axis while the star i
Electronics Forum | Fri Aug 18 14:31:53 EDT 2006 | vikkaraja
I have humming noise comming from my Z axis motor for a while now. It faults out every so often, but not enough to stop production. I even can hear it while machine is in normal production mode. I have replaced the z servo amp. It did not help any. O
winsouce.jpg)