Electronics Forum | Thu Jul 27 15:59:36 EDT 2006 | russ
test at the bare board level consists of opens and shorts. It makes sure that all traces are hooked (connected) up to the appropriate place and they are not shorted to a non common conductor. Russ
Electronics Forum | Thu Jan 02 11:35:30 EST 2003 | Richard
Cleanliness test � �Area Grid Arrays�. Evaluation of residues� resistivity in a specific location on the board. (As compared to �Solvent Extract� evaluation.) We are: SMT assembly, using standard �water soluble� process with micro BGAs (example: C
Electronics Forum | Mon Aug 22 15:57:28 EDT 2005 | pr
Is there a test to check for delamination on a pcb? We are looking at new board houses and along with our standard solderability tests my boss wants to test for delamination. thanks, pr
Electronics Forum | Sun Jul 29 21:23:27 EDT 2001 | nifhail
When carry out the contamination test,do we measure for Chlorides on water soluble and No-clean fluxes? 1) What is the equivalent factor for machines developed to test the board cleanliness, Omega-meter vs Ionograph vs Zero-ion. 2) What values do we
Electronics Forum | Thu Jan 02 12:15:10 EST 2003 | Mike Konrad
Richard, With respect to the Resistivity of Solvent Extract (ROSE) test, the test solution is exceptionally aggressive. With the Zero-Ion for example, the test solution�s resistivity is 150 M-Ohms. Additionally, because test solution is made up of
Electronics Forum | Fri Jan 03 19:17:12 EST 2003 | Mike Konrad
Hi Richard My experience with R.O.S.E. testers has been positive with regard to detecting ionic contamination (even exceptionally low levels). As previously mentioned, a good R.O.S.E tester will be able to detect minuet levels of ionic contaminatio
Electronics Forum | Sun Jul 29 21:33:30 EDT 2001 | CAL
Your Ionograph and Zero-ion Values are set by you. There is no raw pass of fail criteria only the limits you set up. Ionograph is great for bare board resistivity (salt) test just as a pass fail for incoming inspection but this is all per your facto
Electronics Forum | Thu Jul 27 16:54:46 EDT 2006 | pjc
In-Circuit test, or ICT, is the most common method of electrical test for an assembled PCB. It is the most comprehensive and accurate method to ensure that both the PWB and components are working to specification. Not all components however can be el
Electronics Forum | Fri Jan 03 12:12:22 EST 2003 | richard
Good day and thanks for your comments Mike, What did I understood from your notes� 1) ROSE test (�extracting solution�) is probably good enough (with good equipment) to penetrate the space under my micro BGA. 2) I should test 2 parallel batches of
Electronics Forum | Mon Jul 30 21:03:44 EDT 2001 | davef
You should specify the level of res based on the effect of the res on the end-use of the product. J-STD-001 defines cleanliness requirements for ALL flux types, including water soluble and no-clean that you mention. 1 There is no equivalency betwee
