Electronics Forum | Wed Apr 03 12:34:52 EDT 2019 | franjov
Equip-Test main product lines are Test Probes, Test Fixture Kits, Customized ICT & Functional Test Fixtures, Integrated ICT with Function Test capabilities. If you are looking for some of these products just let us know we are global suppliers for th
Electronics Forum | Thu Dec 21 04:27:31 EST 2000 | teohbengee
Need help urgently. Anyone can provide me some information or site on reliability test on PCB assembly like solder joint or anything. Some test like ERSA Test, SHMOO Test, Pull Test, Temperature cycle and humidity Test, vibration Test or any related
Electronics Forum | Fri Aug 20 13:36:46 EDT 2004 | ttye01
We conduct temperature stress test (-40 to +100C)on our products which sits on our expensive test board. This stress test on our product shorten the life span of the test board due to the extreme temperature change. I have tried epoxy coating on the
Electronics Forum | Sat Mar 10 08:05:09 EST 2007 | davef
Here's your test definitions [clipped from the dictionary in the fine SMTnet Library]: * Test, Automated. Computer controlled electrical testing of parts, assemblies, or finished products. * Test, Built-In (BIT). An electrical testing technique whi
Electronics Forum | Thu Mar 22 17:33:38 EST 2001 | davef
Steve, IPC TM-650 Test Methods Manual is a load. IPC TM-650 Test Methods Manual: Section 2.1 Visual Test Methods Section 2.2 Dimensional Test Methods Section 2.3 Chemical Test Methods Section 2.4 Mechanical Test Methods Section 2.5 Electrical Test M
Electronics Forum | Fri Dec 03 04:20:18 EST 2010 | grahamcooper22
Hi In Dec 2008 the IPC J STD 004 was updated to 004B, and I am wondering what the new test conditions are for testing flux Surface Insulation Resistance and Electro Migration Potential within the new spec. I am looking for the recommended test temp
Electronics Forum | Tue Feb 05 14:35:30 EST 2013 | rway
In order to test a reed switch on the Teradyne, you will need an electro-magnet mounted inside the fixture. It will need to be mounted directly under the reed. First perform the passive testing (TVSV or Cont), then the active test. Drive the coil
Electronics Forum | Thu Jun 04 21:04:31 EDT 1998 | Chiakl
I have just been assigned to look into the ionic chromotograhy test on our PCBA but I have zero knowledge. Could anyone help to explain what is this test about? Is it a) a destructive test? b) What is the measurement unit of this test? c) What is th
Electronics Forum | Wed Jun 30 22:14:53 EDT 2004 | Chris SF
I get always a lot of evaluations including results from Solder Spread tests, but it seems everybody creats his own test methode. Is there a official Standard or test instruction for Solder Spread Testing such as IPC, MIL, DIN... Thanks Chris
Electronics Forum | Mon Aug 06 19:54:59 EDT 2007 | wayne_
Anyone of you tested your boards in high power reliability test? I am just wondering whether there is any test procedure / standard for a board undergo high power (current / voltage) testing, and also which solder alloy you have tested with good comm
winsouce.jpg)