Electronics Forum | Fri Jul 30 18:34:51 EDT 2010 | ranas
hi, just want to seek info regarding LF supplier who can do flip chip LF with solder nuggets. our supplier from USA is going to be closed due to financial constraint.. Anybody who can recommend.. asia location is preferrable.. thanks, Ranas
Electronics Forum | Thu Dec 23 15:29:48 EST 1999 | Glen Robertson
Mike - I'm not in the EMS business, but I suspect most of them are very reluctant to reveal much about their quoting process. You might want to try some of the third-party data suppliers like Ceeris (www.ceeris.com), and you can also check the C
Electronics Forum | Sat Nov 06 14:58:45 EST 1999 | Gary Moravchik
Assuming you are using Sn63/Pb37 solder paste, have you tried using a lower temp melting point solder paste for the second pass? For example, use 63/37 for first pass and a Bi58 compound solder paste for the second pass. If I recall, Bi58's melting
Electronics Forum | Fri Feb 02 11:55:34 EST 2018 | psilvm00
Hi Clare, One of the best I ever tried is Smt Low Cost. Is also based in EU. http://www.smtlowcost.com For me faster and better than China. Regards.
Electronics Forum | Fri Feb 02 12:10:21 EST 2018 | psilvm00
Totally agree with you, Adam. I also try to avoid " always China" Check also Smt Low Cost. Is new is good is cheap! and they provide to my company a really good service. www.smtlowcost.com best regards. Paula
Electronics Forum | Sun Apr 11 13:48:33 EDT 2021 | ngumado28898
Hi guys, I'm a newbie for SMT field. Currently, I'm facing a problem that there were many defects such as tombstone, missing, skewed, billboarding that happened with 1 type component (Resistor 0201) with a specific supplier X (we have many supplier b
Electronics Forum | Tue Apr 19 16:50:27 EDT 2016 | vchauhan
Use findchips.com You will be able to find cost and stock same time. You can buy from anyone of those suppliers.
Electronics Forum | Tue Dec 14 14:26:20 EST 1999 | John Thorup
Sure KA, it's done every day. Be sure that the components to be used on the bottom can take the maximum heat of the wave and the delta T of entering the wave. Depending how complex the bottom side is you will get better results with attention paid
Electronics Forum | Sat Mar 05 22:44:44 EST 2005 | gpaelmo
You can also try the Florida Circtech website or call them direct. There is a min. thickness requirement and if the board house does not follow it you will end up with scrap boards after the second pass (from experience). I even sent blank boards to
Electronics Forum | Tue Dec 29 17:29:46 EST 1998 | Dave F
| can some kind of through hole type connector pass through | the smt process (with IR technology)???? | the temperature factor or material factor????? | Flag: Most PTH components are not spec'd for reflow processes. PTH component suppliers, nomin
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
3 Road Xintang， Fuhai Street，Fuyong
Shenzhen, 30 China
Phone: 13713862102
